Filter
Top Products
6
6. Orient the Latch Spacer (67) and the Latch Assembly (32)
as shown. Attach the Latch Spacer and the Latch
Assembly to the Left Bottom Handgrip (82) with the two
1 3/4” Screws (105) as shown. Tighten the two Screws
as tightly as possible.
32
82
105
67
64
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 24). To protect the
floor or carpet from damage, place a mat under the treadmill.
105
3. Orient one of the Handgrip Extensions (34) so the bottom is
open as shown, and insert it as far as possible into the
post on the left Upright (64). If necessary, tap the
Handgrip Extension with a rubber mallet to fully insert it.
Attach the Handgrip Extension with two Extension
Screws (35), one towards the front of the post, and the
other towards the back.
Attach the other Handgrip Extension to the post on the
right Upright (not shown) in the same way.
34
35
35
64
Post
3
4. See the inset drawing. Identify the Left Top Handgrip
(31); there are identifying marks inside of the Handgrips.
Set the Left Top Handgrip on the left Handgrip Extension
(34). Insert two 1/2” Screws (33) into the two holes in
the Handgrip Extension indicated by the arrows.
Tighten the Screws into the Left Top Handgrip.
Important: Do not insert the two 1/2” Screws (33) into
the wrong holes in the Handgrip Extension (34), or
tighten the Screws into the plastic bosses on the bot-
tom of the Left Top Handgrip (31).
31
Bosses
33
34
4
31
43
5
5. Attach the matching Left Bottom Handgrip (82) with three
1/2” Screws (33).
Attach the Right Top Handgrip and the Right Bottom
Handgrip (not shown) as described above.
33
33
33
35
7
82
Open side