Filter
Top Products
12
HOW TO TURN ON THE POWER
Plug in the power cord (see page 10).
Locate the reset/off
c
ircuit breaker near
the power cord. Make
s
ure that the circuit
breaker is in the reset
position.
Next, stand on the foot rails of the treadmill. Find
the clip attached to the key (see the drawing on
page 11) and slide the clip onto the waistband of
your clothes. Then, insert the key into the console.
After a moment, the display will light. Important:
In an emergency situation, the key can be
pulled from the console, causing the walking
belt to slow to a stop. Test the clip by carefully
taking a few steps backward; if the key is not
pulled from the console, adjust the position of
the clip.
HOW TO USE THE MANUAL MODE
Insert the key into the console.
See HOW TO TURN ON THE POWER above.
Select the manual mode.
When the
key is in-
serted, the
manual
mode will be
selected. If a
program has
been selected, reselect the manual mode by
pressing any of the three Programs buttons re-
peatedly until a track appears in the display.
Start the walking belt.
To start the walking belt, press the Start button,
the Speed increase button, or one of the speed
buttons numbered 1 to 10.
If the Start button or the
Speed increase button is
p
ressed, the walking belt
will begin to move at 1
m
ph. As you exercise,
change the speed of the
walking belt as desired by pressing the Speed in-
crease and decrease buttons. Each time a button
is pressed, the speed setting will change by 0.1
mph; if a button is held down, the speed setting
will change in increments of 0.5 mph. Note: After
the buttons are pressed, it may take a moment for
the walking belt to reach the selected speed setting.
If one of the numbered speed buttons is pressed,
the walking belt will gradually change speed until it
reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To
restart the walking belt, press the Start button, the
Speed increase button, or one of the numbered
speed buttons.
Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de-
crease buttons. Each
time a button is pressed,
the incline will change by
0.5%. Note: After the buttons are pressed, it may
take a moment for the treadmill to reach the se-
lected incline setting.
Follow your progress with the display.
When the
manual mode
is selected,
the display
will show a
track that
represents
1/4 mile. As you walk or run, indicators will appear
in succession around the track until the entire track
appears. The track will then disappear and the in-
dicators will again begin to appear in succession.
5
4
3
2
1
3
2
1
Track
Reset
Position
Track