Filter
Top Products
5
1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (88) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (70) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (83).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(88) are resting flat on the floor.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions on page 11 to lower
the treadmill.
Insert the brackets on the Console Base (56) into the
Uprights (84); insert any slack in the Wire Harness (54)
into the right Upright. Thread four Handrail Bolts (48)
with Handrail Washers (47) into the Uprights. Tighten
all four Handrail Bolts.
Make sure that the two indicated Grommets (89) are
pressed into the holes.
3. Remove the two Frame Guide Screws (9) from the left
side of the Frame (5).
Attach the Frame Guide (10) and the Frame Guide
Spacer (11) to the Frame (5) with two Frame Guide
Screws (9) as shown. Note: Be careful not to over-
tighten the Screws. Make sure that the thick end of
the Frame Guide is at the bottom.
83
83
88
70
47
48
84
48
54
89
89
47
56
Bracket
Bracket
88
70
1
2
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver .
10
11
Thick End
5
9
3