Filter
Top Products
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from
other electrical equipment. Reset (switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove
from the product before recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
CAUTION:
TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
TO REPLACE BATTERIES
TO REPLACE HELMET BATTERIES
BATTERY INSERTION
FOR LIGHT
5
4
1 2
3
Remove crest
section over battery
compartment door.
Loosen screw in battery
compartment door with a Phillips/
cross head screwdriver (not
included). Remove door. Remove and
Loosen screw in battery
compartment door with
a Phillips/cross head
screwdriver (not included).
Remove door. Remove and
discard batteries. Insert 3
x 1.5V “AAA” or R03 size
batteries. Alkaline batteries
recommended. Replace
door, and tighten screw.
discard batteries. Insert
3 x 1.5V “AA” or R6
size batteries. Alkaline
batteries recommended.
Replace door, and
tighten screw.
Re-attach crest to
helmet.