Filter
Top Products
GEWINO
STARTED
1.
Charge the Power Pack
n.
1. Plug charger into a
120V
household OuUet.
2.
Charge the power pack for 4hfs.
Nore:
Pack
is
MI
charged
when
new.
3.
Alter charging for 4hrs, unplug
charger and disconnect pack.
4.
IMPORTAM: The first
3
times you
charge the battery, charge for at
least
5.5
hours in order to condiliw
4.
the battery, and run battery until it
is fully exhausted.
RUNNING TIME
Appoximale
running
tvne
is
12-18 min.
Power
-.+may
quit suddenly. Let pack cool, then
recharge
after removing pack trom vehicle.
CAUTION
W
DO
not remove
warm
or hot pwe! packs. Walt
20
man
unll
pack
has cooled
Recnarging
loo
early w~ll Ylorlen pack llle
Recharging near lire orhigh teripralure is dangerous..
Do not recharae
Dacks
lhal show wear
or
leakaae.
Always unpnu<ciwer pack when not ~n use.
Do
not
dmpose of pack
in
fire, explosm
or
personal
illpry
may occur.
D~spose ol power packs properly, do not aisassemble.
.
Always remove power pa& from vehicle belore charging.
Do
n6t
use
charger fwany use other than inshuctedin riirectimns.
2.
Install Battery In Hand Controller
1.
Remove
cover
ol battery
.
compartment on the
hand remote.
2.
lnserl one 'W16LR61
Heavy Duly Battery.
3.
0%
sure the
+
and
-
are
properly matched.
NoIe
FOR
BEST
PERFORMANCEALWAYS
USE
ALKALINE
BAl7ERIES.
3.
Install
Charged
Power
Pack
in Vehicle
TO INSERT BATTERY
1. Unlock battery door
by tuning latch to
the right.
2.
Siide fully charged
Ni-Cd Battery
pack
forward.
3.
Relock the battery door.
TO REMOVE BATTERY
1.
Unlatch battery door.
2.
Slide battery backward.
To ensure proper function
*Do not mix old and new batterres.
-Do not mix alkaline, standard,
or
rechargeable batteries.
.Batteries installation should be done by an adult.
-Non.rechargeable balteries are not
to
be
recharged.
-Rechargeable balteries are to be removed trom the toy
betore being
recharged (if removable).
.Rechargeable batteries are only to be charged underadun supervision
lil
removable1
.~h~n~b#~esameor-alen(vpe~recommendedarebbem
.Ballr~~es are to be lnseneo u.lh correct pdanty.
.Exhausted
ballenes are to be remoied trom the toy
.The supply terminals are not to be shorl.circuited.
Driving
1.
Tum On/OH switch
on vehicle to the
On position.
2.
Operation
3.
When you're done driving your Havoc
RC
turn the On/OH switch
I ,I
II
I
.I,
I
,I
I
I,
.
I
)
/.