Hasbro 06717 Games User Manual


  Open as PDF
of 4
 
RIDE-ON
SCOOTER
BBAASSEE
LLAATTCCHH
BBAASSEE PPOOSSTT
TTiigghhtteenn SSccrreewwss
HHAANNDDLLEEBBAARR
SSEECCTTIIOONN
5. Attach Handlebar Section
Press latch on vehicle body, slide arm of handlebar section through hole in vehicle body, and
snap handlebar arm into post on base. Tighten 2 screws into base post and handlebar arm.
6. Attach Label
NOW YOU’RE READY TO ROLL OR RIDE…YOU DECIDE!
This unique toddler toy offers 2 kinds of vehicle play!
Use it as a ride-on or scooter!
As your child grows steadier on his feet, this toy
easily converts to a child’s first scooter that
encourages balance, coordination and timing.
If the toy is in ride-on mode:
• Remove dashboard unit from handlebar
section by lifting it up.
• Press latch on vehicle body and raise vehicle
body until it locks into place. Be sure the
word “LOCKED” appears on latch.
• Snap clip on unit to post in dashboard
holder. (To remove dashboard unit, lift up
on unit from bottom.)
Now you’re ready to roll!
For growing toddlers, the RIDE2ROLL Scooter is
a foot-to-floor ride-on that offers extra height
and leg room.
If the toy is in scooter mode:
• Push latch on vehicle body downward and
bring vehicle body down until it locks into
place. Be sure the word “LOCKED” appears
on latch.
• Slide the clip on the dashboard unit into slot
in the center of handlebar section.
Now you’re ready to ride!
L
O
C
K
E
D
RRIIDDEE--OONN
DDAASSHHBBOOAARRDD
RROOLLLL--OONN
DDAASSHHBBOOAARRDD
PPuullll oouutt ttoo CCoonnvveerrtt ttoo
SSCCOOOOTT MMOODDEE
PPuusshh DDoowwnnwwaarrdd ttoo CCoonnvveerrtt
ttoo RRIIDDEE--OONN MMOODDEE
 previous