Filter
Top Products
ASSEMBLY:
11.. AAttttaacchh WWhheeeellss
Tip body/chassis on its side. Snap wheel onto axle,
with flat side of wheel against chassis. Repeat for
remaining 3 wheels.
22.. AAsssseemmbbllee HHaannddlleess
To snap front and rear handles together: Place rear
handle upside down on flat surface. Holding front
handle with back facing rear handle and perpendicular
to rear handle, snap posts on front handle into holes in
rear handle.
33.. AAttttaacchh HHaannddllee AAsssseemmbbllyy ttoo BBooddyy
Lift body and remove cardboard insert.
Turn body/chassis on its side. Insert front handle
through slot in body.
WHEEL
CHASSIS
FRONT HANDLE
REAR HANDLE
BODY
CARD-
BOARD
INSERT
FRONT
HANDLE
SLOT
Fit axle on rear handle into ridges in underside of body.
Place handle retainer over axle (retainer fits only one
way). Using the 4 plain #6 screws and Phillips/cross
head screwdriver, attach retainer to body.
NOTE: If body is locked closed, see back panel for
conversion instructions.
AXLE
RIDGES
SCREWS
HANDLE
RETAINER