Filter
Top Products
Page 5SKU 96529 For technical questions, please call 1-800-444-3353.
Use the remaining Draw Strings to secure the rest of the Fabric Cover (1) to the 5.
Main Support Frame (3) and Side Frames (2). (See Assy. Diagram.)
Remove the Bolt (11), Flat Washer (7), and Wing Nut (10) from one end of the 6.
Rear Cross Bar (12). (See Figure A and Assy. Diagram.)
With assistance, position the Hunting Shelter against the trunk of a tree. Adjust 7.
the Rear Cross Bar (12) to t rmly against the tree trunk. Then secure the Hunt-
ing Shelter to the tree trunk by re-installing the Bolt (11), Flat Washer (7), and
Wing Nut (10) on the Rear Cross Bar. (See Figure A and Assy. Diagram.)
NOTE: 8. Make sure both Bolts (11), Flat Washers (7), and Wing Nuts (10) on the
Rear Cross Bar are rmly tightened.(See Figure A and Assy. Diagram.)
Attach the Side Cover (18) to the Side Frame (2) using the 8 Hooks (17). See 9.
diagram on page 7.
Adjust the height of the shelter so the Side Cover touch the ground.10.
REAR CROSS BAR (12)
BOLT (11)
FLAT WASHER (7)
WING NUT (10)
FIGURE A
See cover
page photo.
Attach the bottom of the Side Cover (18) to the ground using the U-Shaped land-11.
scape Staples (19). See Parts List and Assembly Diagram on page 6 and 7.
REV 08e