Filter
Top Products
9
6. See the left inset drawing in step 5. Identify
the outer side of the remaining Frame Spacer
(11).
Hold the Frame Spacer (11) between the Left
Upright (53) and the Lift Frame (23), with the
outer side of the Frame Spacer facing the
L
eft Upright. Attach the Left Upright to the Lift
Frame with an M10 x 60mm Patch Bolt (1), an
M10 Flat Washer (14), and an M10 Star Washer
(9); do not fully tighten the Patch Bolt yet.
6
53
14
11
9
23
1
1
14
9
53
11
23
T
op View
7. Set the Console Assembly (91) face down on a
soft surface to avoid scratching the Console
Assembly. Hold the Right Handrail (33), which
has a large hole in one side, near the Console
Assembly.
Next, insert the console wire and the tie into the
hole in the side of the Right Handrail (33). Using
needlenose pliers, pull the console wire out of
the hole near the bracket on the Right Handrail.
See the inset drawing. Insert the included wire
tie through the indicated small hole in the Right
Handrail (33). Make sure that the console wire
has been secured to the side shown, and
tighten the wire tie.
Then, set the Right Handrail (33) on the Console
Assembly (91). Make sure that no wires are
pinched.
7
Console
Wire
Large
Hole
33
Bracket
91
Tie
Wire Tie
Small
Hole
33