Fuji Bikes Team Pro (US) Bicycle User Manual


 
CARBON FRAME GUIDE
Please read the following instructions. If you have any doubt regarding your mechanical
ability, visit your local authorized Fuji dealer. Fuji recommends that the bottom bracket,
headset, rear derailleur and water bottle bolts be installed according to recommended torque
specification.
Warning: Failure to follow any warning may result in a catastrophic failure of the seat
post, resulting in serious injury or death. This phrase may not be repeated in
connection with each warning.
Assembling a complete bicycle is a complicated task. Only a trained and experienced bicycle
mechanic should install components to this frame.
Warning: Bicycle assembly requires training and experience. If you do not have the
experience and training as a bicycle mechanic, DO NOT attempt the assembly of this
bike. Failure to follow this warning may result in serious injury or death.
Follow all torque specifications to ensure the best assembly possible and to prevent any
damage to the components or frame. For correct torque specifications as well as
recommended loads that the contact points of the frame are capable of accepting, please refer
to the owner’s manual.
Warning: Failure to follow torque specifications will void your warranty. It may also
damage the frame, which may not be visible to the eye. If there is damage to the
frame, this can result in loss of structural integrity, which may result in serious injury
or death.
All bicycle components should be compatible with each other (i.e. handlebar, handlebar stem,
seat post, saddle, brakes, etc.). Any doubt regarding compatibility should be addressed with
an authorized Fuji dealer.
Warning: You should never clamp the frame when placing this bike in a repair stand.
Always clamp the seat post. Clamping the frame can cause serious damage to the
frame which may not be visible. This will impair the structural integrity of the frame.
Failure to follow this warning may result in serious injury or death.
Your Fuji frame does not require any pre-installation preparation to the bottom bracket or
head tube. Surfaces are prepared at the factory. Grease will still need to be placed on the
bottom bracket threads and the head set cups. If necessary, you may need to chase the
bottom bracket threads.
BOTTOM BRACKET:
Clean and grease bottom bracket shell threads before installing.
Recommended torque is 442 in-lbf (50 Nm).
Do not exceed maximum torque of 670 in-lbf (70 Nm).
HEADSET INSTALLATION:
All Fuji road bikes come with integrated headsets. No headset tool is required. Clean and
grease headset cups before installing bearings. Do not mix headset components with other
headsets. For example, crown races vary from headset to headset.
REAR DERAILLEUR: