Filter
Top Products
a. Place the saddle in the clamp and adjust to the desired angle.
b. The adjusting bolt on the bottom side of the head of the seat post requires a 6mm
allen key. Recommended torque is 100 in-lbf (11.3Nm). Do not exceed maximum
torque of 120 in-lbf (13.5Nm).
c. If the nose is tilted at an undesirable angle, loosen the 6mm allen bolt slightly and
reset the angle of the seat. Once desired seat angle is achieved, tighten 6mm allen
bolt per torque specs.
4. SEAT POST HEIGHT ADJUSTMENT / TORQUE
Once the desired angle of the saddle has been adjusted, place the seat post at the required
height for proper leg extension. Using an allen head, tighten seat post clamp to recommended
torque spec.
NOTE: Recommended torque is 50 in-lbf (5.65 Nm). Do no exceed maximum torque of 60 in-
lbf (6.78 Nm). Exceeding this limit can result in damage to the seat post.
All Fuji carbon seat posts are marked with a minimum insertion line. This is the minimum
amount of insertion required for the seat post to remain structurally safe. Some frames will
require additional insertion to ensure that the frame remains structurally sound as well. The
base of the seat post should be inserted enough into the seat tube to extend below the bottom
of the top tube.
Warning: Fuji carbon seat posts are made to be lightweight, and are not suitable for
all riders and all possible uses. If the rider is approaching 250 lbs/113.4 kg in weight,
Fuji recommends against the use of this seat post. This seat post should be used only
for road riding and not mountain bike use. Failure to follow this warning may result in
a catastrophic failure of the seat post, causing serious personal injury or death.
Warning: Seat post is NOT to be extended beyond the minimum insertion line.
Extension beyond the minimum line can result in failure, causing serious injury or
death.
Warning: It may be visually difficult to identify damage to the composite material. If
the external composite surface is dented, frayed, gouged, deeply scratched, fractured,
chipped or otherwise damaged, the component should be replaced. If seat post has
been involved in a crash or impact, even if there is no visible damage, Fuji or an
authorized Fuji dealer should inspect the product.