Filter
Top Products
FT96
-20-
Belt/deck lubrication procedure:
Do not lubricate with other than FUEL approved lubricant. Your treadmill comes with one tube of
lubricant and extra tubes can be ordered directly from FUEL. There are commercially available lube
kits, but the only one currently approved by FUEL is Lube-N-Walk. These kits come with an
application wand that makes applying the lubrication easier. The kits can be purchased directly from
Lube-N-Walk here: http://www.jadfitness.com/
. You can also purchase FUEL lubricant from our
website www.fuelfitnessusa.com under the products tab.
Keeping the deck lubricated at the recommended intervals ensures the longest life possible for your
treadmill. If the lubricant dries out, the friction between the belt and deck rises and places undue
stress on the drive motor, drive belt and electronic motor control board, which could result in
catastrophic failure of these expensive components. Failure to lubricate the deck at regular intervals
may void the warranty.
The deck comes pre-lubricated and subsequent lubrication should be performed every 180 hours of
use. The console has a built in lubrication reminder indicator that lights every 180 hours of use. To
lubricate the deck with the tube of lubricant supplied it will be necessary to loosen the walking belt.
Using the 6 mm Allen wrench supplied, loosen the two rear roller adjustment bolts -- located in the
rear end caps enough to get your hand under the belt (5 10 turns). Make sure to loosen both
bolts the same amount of turns and also remember how many turns, because when finished you
will need to tighten the bolts back to the point they were before.
Once the belt is loose, wipe the deck with a clean lint free cloth to remove any dirt. Apply the whole
tube of lubricant onto the deck surface about 18 inches from the motor cover. Squeeze out the
contents of the tube across the deck (parallel to the motor cover) in about a one-foot line, like
toothpaste on a toothbrush. The one-foot line should be in the middle of the deck at approximately
equal distance from both side edges of the belt. You want the lubricant to be applied about the spot
that your feet would hit the belt as you are walking. This should be about 18 inches from the motor
cover, but you may want to walk on the treadmill before loosening the belt to note where your feet
land on the belt. If you mostly run on the treadmill the spot where your feet land may be different
from walking.
Once the lubricant is applied, tighten the rear roller bolts the same amount of turns as when you
loosened them. Run the treadmill at about 6 mph without walking on it for about a minute or two to
make sure the belt stays in the middle of the deck. If the belt tracks to one side then follow the belt
tracking instructions to remedy. Now the deck is lubricated and you should walk, not run, on the
treadmill immediately for at least 5 minutes to ensure the lubricant is evenly distributed. If you
purchase a Lube-N-Walk kit, follow the instructions that come with it to apply the lubrication.