Filter
Top Products
TRIM
once to stop counting and then
press S2 button again.
5. Upon completion of a countdown,
if STOP is selected as the action to
be taken, the TIMER stops at zero
,a tune will be emitted and the
backlight will flash; if REPEAT is
selected, the TIMER repeats its
countdown with the rep number
updated. If the TIMER reset time is
less than 30 seconds, a beep will
be emitted. Otherwise, a tune will
be emitted and the backlight will
flash.
TO SET THE HEAT TIMER
1. Press S3 button to select HEAT
TIMER mode.
2. Press S4 button, the “SET”
message appears and the Minute
digits blink on the display.
3. Press S1 button to increase the
digits by five units, or press S2
button to decrease the digits by five
units. Holding down either button
will speed up the process.
4. After finished making all the
settings, press S4 button to confirm
the settings.
NOTE: The HEAT TIMER can count up
to a maximum time of 35.00
(35minutes).
TO USE THE HEAT TIMER
1. Press S3 button to select HEAT
TIMER mode.
2. Press S1 button to start a
countdown.
3. To stop counting, press S2 button
once. Press S1 button to resume
from where it left off.
4. To reset the HEAT TIMER, press S2
button once to stop counting and
then press S2 button again.
5. Upon completion of a countdown,
a tune will be emitted and the
backlight will flash.
NOTE: The HEAT TIMER is
independent of the TIMER. Both may
be running at the same time.
TO SET THE ALARM TIME
1. Press S3 button to select ALARM
mode.
2. Press S4 button, the “SET”
message appears and the alarm
entry to set blinks on the display.
3. Press S1 button or S2 button to
toggle between ALARM 1 and
ALARM 2.
4. Press S3 button, the Hour digits
(including AM/PM for 12-hour
format) will blink.
5. Press S1 button to increase the
digits by one unit, or press S2
button to decrease the digits by one
unit. Holding down either button
will speed up the process.
6. Press S3 button, the Minute digits
will blink.
7. Press S1 button or S2 button to set
the Minute digits.
8. Press S3 button, the alarm
frequency will blink.
9. Press S1 button or S2 button to
cycle forward or backward
respectively the alarm frequency
to be selected (DAILY, WEKDAYS,
WEEKENDS, day of the week and
WKLY).
10.After finished making all the
settings, press S4 button to confirm
the settings.
NOTE: The ALARM TIME displayed is
in the same Time Format as the
primary time.
NOTE: A tune will go off and the
backlight will flash for 20 seconds at
the designated time when the ALARM
is activated.
NOTE:The alarm will automatically be
activated after being set.
WHEN AN ALARM OR HOURLY
CHIME GOES OFF
A tune will go off by the hour if the
Hourly Chime function is activated and
the same will happen at the designated
time when the ALARM is activated. To
stop the tune, press any button.
If the alarm tune is done without any
user interruption, the watch will
automatically enter a snooze mode.
The ALARM will go off again after 5
minutes but for only once.
TO USE THE BACKLIGHT
Press S5 button to turn on the
backlight for three seconds.
FS-8124-1064-02
GROMATIDE-IMS V3 18-11-2008
To reduce carbon foot print, these
Freestyle instructions are printed with
soy inks on recycled paper.