Freestyle FS80961 Watch User Manual


 
TRIM
TIDE 3.0-03
FOLLOW THESE 8 TIPS TO GET THE
MOST OUT OF YOUR NEW WATCH!
8. It is advisable to have your watch
pressure tested annually and to
re-furbish your watch every 2-3
years to extend the life of the watch.
1. Never Pull out the crown or operate
the pushers/buttons under water.
3. If your watch is exposed to
saltwater it is very important to
wash it thoroughly under tap water
and wipe dry with a soft cloth.
Keep it clean!
7. Never try to remove the caseback,
leave this to a certified watch repair
technician or Freestyle service
center. This will help in preventing
water leakage from improper
battery replacement.
4. Sever impacts or drops may affect
your watches water resistance
and performance.
6. Avoid exposing your watch to
chemicals, soaps or solvents as
they deteriorate the water resist
seals in your watch.
2. Make sure your crown is returned
to the original position before you
expose your watch to water.
5. Avoid exposing your Freestyle
watch to extreme temperatures
such as in a hot shower, Jacuzzi,
sauna or hot tub. The combination
of extreme heat and water may
cause your watch to lose some of
its water resistance.
the product, including but not limited
responsibility. This warranty applies
LIMITED LIFETIME WARRANTY
Freestyle U.S.A. warrants, to the
original purchaser, that its watches
are free from defects in materials
and workmanship for the lifetime
of the watch (under normal use)
from date of original purchase.
The following are not covered under
warranty: battery, strap/bracelet/
band and crystal.
Accidental breakage or damage
due to normal wear or misuse of
to the mathematical accuracy of
the product, is not covered under
this warranty. Some states do not
allow limitations on how long an
implied warranty lasts, or the
exclusions of or limitations on
consequential damages, so the
above limitation may not apply to
you. This warranty gives you
specific legal rights, and you may
have other rights, which vary from
state to state.
Under this warranty FREESTYLE
will make any necessary repairs, if
applicable, at no cost to you the
consumer. Any repair needed that
is not under warranty will be at the
cost of you the consumer. Proof
of purchase and / or original receipt
it needed to validate your warranty.
Your warranty is voided by any
servicing out by a non-authorized
agent. Any other form of guarantee
to you by the retailer is his / her
to watches purchased in the United
States. For watches purchased
outside the United States, please
contact you authorized
FREESTYLE dealer for warranty
information.
Please send to the address below
and include the following (w/ the
form included on either this page
or the flipside)
1)
A copy of your original sales
receipt
2)
Your printed name, address,
phone number and a brief
description of the problem.
3)
A Check, Money Order payable
to Freestyle USA in the amount
of $8.50 for processing and
handling. If using a Credit Card,
be sure to include card number
and expiration date on included
form.
Attn: Individual Returns
FREESTYLE
47-50 33rd Street
Long Island City, NY 11101
Should the warranty on your watch
no longer be valid or found to be
voided, please see the enclosed
mailing form (on this page or
flipside) for replacement costs per
item. Please do not include any
special watchband or any other
items of personal value in your
shipment. Allow 30 days for
processing and the return of your
serviced watch.
www.freestyleusa.com
1-888-222-5230 ext.502
Attn: Individual Returns
47-50 33rd Street
Long Island City, NY 11101
www.freestyleusa.com
visit our site
Battery $ 4.00
Case 10.00
Bezel 6.00
Band(Polyurethane) 12.00
Band(Leather) 12.00
Band(Metal) 20.00
Band(Nylon) 7.00
Processing and handling 8.50
Total $
Check or Money Order
Master Card
Card #
Exp Date
Visa
Name
Adress
Phone #
Signature
www.freestyleusa.com
1-888-222-5230 ext.502
,a tune will be emitted and the
backlight will flash; if REPEAT is
selected, the TIMER repeats its
countdown with the rep number
updated. If the TIMER reset time is
less than 30 seconds, a beep will
be emitted. Otherwise, a tune will
be emitted and the backlight will
flash.
TO SET THE HEAT TIMER
1.Press S3 button to select HEAT
TIMER mode.
2.Press S4 button, the “SET”
message appears and the Minute
digits blink on the display.
3.Press S1 button to increase the
digits by five units, or press S2
button to decrease the digits by five
units. Holding down either button
will speed up the process.
4.After finished making all the
settings, press S4 button to confirm
the settings.
NOTE: The HEAT TIMER can count up
to a maximum time of 35.00
(35minutes).
TO USE THE HEAT TIMER
1.Press S3 button to select HEAT
TIMER mode.
2.Press S1 button to start a
countdown.
3.To stop counting, press S2 button
once. Press S1 button to resume
from where it left off.
4.To reset the HEAT TIMER, press S2
button once to stop counting and
then press S2 button again.
5.Upon completion of a countdown,
a tune will be emitted and the
backlight will flash.
NOTE: The HEAT TIMER is
independent of the TIMER. Both may
be running at the same time.
TO SET THE ALARM TIME
1.Press S3 button to select ALARM
mode.
2.Press S4 button, the “SET”
message appears and the alarm
entry to set blinks on the display.
3.Press S1 button or S2 button to
toggle between ALARM 1 and
ALARM 2.
4.Press S3 button, the Hour digits
(including AM/PM for 12-hour
format) will blink.
5.Press S1 button to increase the
digits by one unit, or press S2
button to decrease the digits by one
unit. Holding down either button
will speed up the process.
5.Press S3 button, the Minute digits
will blink.
6.Press S1 button or S2 button to set
the Minute digits.
7.Press S3 button, the alarm
frequency will blink.
8.Press S1 button or S2 button to
cycle forward or backward
respectively the alarm frequency
to be selected (DAILY, WEKDAYS,
WEEKENDS, day of the week and
WKLY).
9.After finished making all the
settings, press S4 button to confirm
the settings.
NOTE: The ALARM TIME displayed is
in the same Time Format as the
primary time.
NOTE: A tune will go off and the
backlight will flash for 20 seconds at
the designated time when the ALARM
is activated.
WHEN AN ALARM OR HOURLY
CHIME GOES OFF
A tune will go off by the hour if the
Hourly Chime function is activated and
the same will happen at the designated
time when the ALARM is activated. To
stop the tune, press any button.
TO USE THE BACKLIGHT
Press S5 button to turn on the
backlight for three seconds.