Filter
Top Products
31
IMPORTANT! The mark made on your screen from the stylus and the location
of the tip of the stylus may not align.When this happens,you need to calibrate
the stylus.
• Turn Pixter® power on. Wait until you see the Home Screen.
• Turn Pixter over and locate the calibration hole.
• Insert, push and hold the stylus in the calibration hole.Turn Pixter over
so that you can see the screen.
• When you see two ,remove the stylus from the calibration hole.
• First touch the in the upper left corner with the tip of the stylus.
• Then,touch the in the lower right corner with the tip of the stylus.
Calibrating the Stylus