Filter
Top Products
6 7
Controller Layout
Playing Games
Start Up
With the batteries
properly installed and the
IR and converter units
connected you are ready
to begin playing with your
101-In-1 Action Games
Plug and Play. Make
sure that the Off/On
switch on the battery
housing is set to the ON
position. Each player
should turn their
individual controller on.
You will see the system’s
title screen come on for a
moment. You can skip
this screen by pressing
the start button on
controller 1 (Black). You
will then be taken to the
game selection screen.
NAVIGATING THE
GAME SELECTION
SCREEN
With either the
controller’s D-Pad or
Joystick you may scroll
up and down the list of
games. You can also use
left and right to skip
between the several
pages of games. Once
you have found the game
that you’d like to play,
press start. Within
seconds the game’s
start-up screen will
appear.
Note: Only Player 1
(Black controller) can
select games.
Directional Pad
(D-pad)
Joystick
A button
B button
Turbo
Buttons
Reset
Start
Reset
You can reset the system at any time with the reset button.
Turbo Buttons
These buttons act as the equivalent of pressing either the A or B
button rapidly.
Note: Each individual game uses the buttons and controls differently.
See instructions for each game for the function of buttons.
When the controllers are on you will see a light flash from the
center (just about the reset/start buttons). This indicates that
the controllers are powered and working.