Filter
Top Products
FX40HR MOTORIZED TREADMILL
Visit us at: www.evofitness.com
20
STABILIZER ADJUSTMENT
How to level the treadmill:
An uneven floor or improper stabilizer level can cause the treadmill to wobble during use as well as the incline
adjustment to function incorrectly. Please follow the procedure described below to make sure the treadmill stabilizer
is adjusted correctly prior to use. You may need the assistance of another person to perform this adjustment.
1. To perform the stabilizer adjustment
you first need to bring the treadmill to
the highest incline level as shown in
drawing 1. After you’ve completed the
assembly procedure plug in the power
cord and switch on the POWER
SWITCH. Insert the Safety Key and
press the START button to quick start
the treadmill. Press the INCLINE UP
button until the deck reaches its
highest incline level. Now press the
STOP button and pull out the Safety
Key. Switch off the POWER SWITCH
and unplug the power cord.
1. Raise deck to highest incline level.
2. Inspect the two stabilizers (one per
side) located underneath the base
frame. The treadmill should sit on the
floor with both stabilizers and all four
cushions resting firmly on the floor as
shown in drawing 2. Shake the
handlebars back and forth to check if
they are resting firmly on the floor. If
they are not, pull the handlebar
backward to adjust the stabilizers as
shown in drawing 3. Simply turn the
stabilizers like a screw to adjust their
heights. Repeat this until the treadmill
sits firmly on the floor.
2. Check position of stabilizers and cushions.
3. Tilt treadmill to access stabilizers.