Filter
Top Products
FX20 MOTORIZED TREADMILL
Visit us at: www.evofitness.com
24
MOTION CONTROL OPERATION
How to use MOTION CONTROL
(
Note:
p
hotos ma
y
var
y
from actual treadmill
)
:
1. Press the button on the console to switch
the motion control function on and off:
• When the LED light is ON the MOTION
CONTROL is active.
• When the LED light is OFF the MOTION
CONTROL is off.
2. After switching on the MOTION CONTROL
wave your right hand approximately 6 inches
above the motion sensor on the right handle bar
to increase the speed. The sensor will sound
one short BEEP per scan and speed up by 0.1
MPH per BEEP. Holding your right hand
approximately 6 inches above the right sensor
constantly results in the sensor sounding one
long BEEP per second and speeding up by 0.5
MPH per BEEP.
2. Use right sensor to speed up.
3. Wave you left hand approximately 6 inches
above the motion sensor on the left handle bar
to decrease the speed. The sensor will sound
one short BEEP per scan and decrease speed
by 0.1 MPH. Holding your left hand
approximately 6 inches above the left sensor
constantly results in the sensor sounding one
long BEEP per second and decreasing speed
by 0.5 MPH per BEEP.
3. Use left sensor to slow down.
4. Wave both hands approximately 6 inches above
both motion sensors at the same time. The
sensor will sound two short BEEPs then stop
the belt.
• Always switch off the MOTION CONTROL
function by pressing the
button before
turning off the power to the treadmill.
4. Use both sensors to stop belt.