Diamondback 1150Ub Treadmill User Manual


 
9
1 1 5 0 S E R I E S O W N E R’S M A N U A L
1150St Assembly Instructions
Frame Assembly
1. Place rear stabilizer bar into the receptor and align the screw
holes.
2. Insert and tighten the two M8 x20mm screws, from stabilizer bar
hardware bag, with an Allen wrench.
Console Mast Assembly
1. Slide console mast cover onto console mast, making sure it is
facing the right direction.
2. Insert the main wire harness into the bottom opening of the console
mast tube. Push the harness up to the tube until the connector of
the harness appears in the opening at the top of the tube.
WIRING HARNESS INSTALLATION HINT: Straighten the loops
of the wire harness so that it can slide smoothly into the
console mast. Move the console mast cover all the way to
the top. Then hold the bottom of the console mast next to
the console mast receptor and point the top of the console
mast downward.
3. Install the console mast by sliding it onto the console mast
receptor while pulling the wire harness. This will keep the slack
out of the harness so the wires will not be pinched and short
out. Insert and tighten the four M8x12mm, from console mast
hardware bag, with an Allen wrench.
4. Place console mast cover in place and align it with screw holes. Insert
and tighten four M5x16mm screws using a Phillips screwdriver.
Handlebar Assembly
1. Insert the hand pulse harness through the opening of the console
mast and out of top of the console mounting plate.
2. Assemble the handlebar onto the mount and insert and tighten the
four M8x12mm screws, from handlebar hardware bag, using an
Allen wrench. Be sure not to pinch the hand pulse harness during
this procedure, as this will damage the electronic console.
Console Assembly
1. Connect both plugs, from main wire harness and hand pulse
harness, to the plug receptors on the backside of the console,
taking care to install correctly (see plug alignment marks).
WIRING HARNESS INSTALLATION HINT: Any excess wiring
must be carefully inserted (“stored”) back into the console
mast before installing the console onto the console mounting
plate.
2. Fasten the console to the console mounting plate with the four
M5x12mm screws and washers using a Philips screwdriver.
Handrail Assembly
1. Place the handrail supports into their receptors on the stabilizer bar.
Insert and finger tighten eight M8x12mm bolts, from handrail as
-
sembly hardware bag, 4 on each side, to secure these supports.
2. Assemble upper handrails into handrail supports. Insert and finger
tighten eight M8x12mm bolts, from handrail assembly hardware
bag, 4 on each side, to secure these handrails.
3. Place handrail clamp cover onto handrails. Assemble the handrail
clamp cover and handrails onto the upper portion of the console
mast. Insert and finger tighten two M8x55mm bolts.
4. Tighten all 18 bolts of handrail assembly with an Allen wrench.
Waterbottle
1. Place the bottle holder on the console mast. Insert and tighten
the two M5x12mm screws using a Phillips screwdriver.
2. Snap the water bottle into the holder.
Leveling Pad
1. Adjust both leveling pads, located on the bottom of stabilizer
bar, to ensure your equipment is leveled with floor.