Filter
Top Products
4
replacement part not supplied by Saris Cycling Group, Saris Cycling Group shall not be liable for any cost, damage, failure or loss caused by the use of
such unauthorized service or parts.
Cautions
Before starting any exercise program, consult with your physician or health professional. He or she can h
elp establish the exercise frequency, intensity (tar-
get heart rate, power zone) and time appropriate for your particular age and condition. If you have any pain or tightness in your chest, an irregular heart-
beat, shortness of breath, feel faint or have any discomfort while you exercise, STOP! Consult your physician before continuing.
Failure to follow any of these safeguards may result in injury or serious health problems.
*Do not remove feet from pedals while CycleOps Indoor Cycle flywheel is in motion.
*Do not attempt to ride the bike at high RPM's or in a standing position until you have
practiced at lower RPM's.
*Do not place fingers or any other objects into moving parts of the exercise equipment.
*Keep children and pets away from the CycleOps Indoor Cycle while the machine is in use. Do not allow children to ride on the CycleOps Indoor Cycl
e.
Pedal travel ranges are designed and intended for adults.
*Never turn pedal crank arms by hand. To avoid entanglement and possible injury, do not expose hands or arms to the drive mechanism.
*Do not dismount the CycleOps Indoor Cycle until both the pedals and the flywheel are at a complete STOP.
*After exercising, turn the adjustment control knob clockwise to increase tension so the pedals will not rotate freely and possibly hurt someone.
Heart Rate Monitor Strap
Position the heart rate monitor strap on your torso as pictured in figure 1. The strap should rest just beneath the pectoral
muscles of the chest. Make sure the electrodes on the strap are slightly moist where it contacts the skin for best results.
The heart rate strap must be worn to enable the heart rate functionality of the Comp 200E and Pro 300PT models.
Bracket
When first setting up the CycleOps Indoor Cycle you must attach the console bracket to the bike. To do this follow the instructions below:
Installation
Figure 1
A. Place bracket onto the handlebars as shown below.
B. Insert screws through console bracket, handlebar bracket, and tighten together.
C. Slide console onto base.
D. Connect the console wire to the Indoor Cycle frame wire by removing the twist tie
on the indoor cycle frame wire.
E. Discard the twist tie, attach the plastic grommet to the console wire as shown.
F. Connect the console wire to the indoor cycle frame wire.
G. Push connected wire into the Indoor Cycle frame until the plug is inserted completly; then inse
rt plastic grommet
into frame.
A
B