Filter
Top Products
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation
is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent
fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
•
Never stor
e tent, even for a short period of time, without
drying it thoroughly and brushing off caked dirt. Do not pack
stakes or poles inside your tent. Use separate storage bag.
•
ST
AKES SHOULD BE REMOVED BY PULLING ON THE ST
AKE
ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE
LOOP TO REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
3
Attach Tent to Frame
Using Frame Clips
Add Brow Pole
– Attach frame clips along the edges of
tent to frame poles. (illus. 6), (illus. 7)
– Assembled Brow Pole by interlocking
shock corded sections.
– Insert Brow Pole into the grommets
on the pole clips above the door.
(illus. 7)
– Connect the two frame clips above
the door to the Brow Pole. (illus. 7)
– Make any adjustments to the tent
corner stakes that are needed.
4
Attach Rainfly
– Drape Rainfly over tent frame, with
vestibule area over front door. (illus. 8)
– Connect the four clips (found at the
Rainfly corners) to the clips located at
the corners of the tent. (illus. 9)
– Stake out vestibule and rainfly sides.
– Secure Rainfly with Frame Ties located
on underside of fly to Gold Brow Pole.
(illus. 10)
– Attach Guy Lines to Guy Wing on the
sides of the Rainfly and stake out
(illus.10).
illus. 7
Assembled tent without
Rainfly. Note the frame clips
located on edge of tent.
illus. 6
Frame Clips
illus. 10
Completed tent
with Rainfly.
illus. 8
Guy Line
illus. 9
Rainfly clips
onto pole
stake loop
Frame Ties
Br
ow Pole
Grommets
PRINTED IN CHINA
©
2005
The Coleman Company, Inc. All Rights Reserved.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com