Coleman X1 Camping Equipment User Manual


  Open as PDF
of 2
 
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation
is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent
fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
•
Never store tent, even for a short period of time, without
drying it thoroughly and brushing off caked dirt. Do not pack
stakes or poles inside your tent. Use separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE
ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE
LOOP TO REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
3
Attach Rainfly
– Layout the Rainfly and locate the logo
(illus.6)
– Drape Rainfly over tent frame, the logo
should be at the foot of the tent. (illus. 7)
– Connect the clips on the rainfly
(found at the Rainfly corners) to the stake
loops at the corners of the tent. (illus. 7 & 8)
– Stake out Rainfly at the front rear and
on each side of the zippered door/vestibule.
Pull stake loops out away from tent until
Rainfly is taut. (illus.7)
illus. 7
Completed tent
with Rainfly. Note
where Rainfly hooks attach
and where to stake out rainfly
illus. 8
Rainfly clips
to tent
stake loop
Rainfly stake loop
Rolls up and attaches
with toggle & loop for
easy access or added
ventilation
Two Rainfly stake loops
on each side
Printed In China Rev. 11/07
© 2000 The Coleman Company, Inc. All Rights Reserved.
illus. 6
Rainfly shown
with clips
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
 previous