Filter
Top Products
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN KOREA, ASSEMBLED IN CHINA
PRINTED IN CHINA Rev.7/03
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be mini-
mized by removing wet clothing from your tent and by providing good ventila-
tion through the tent.
•
Never store tent, even for a short period of time, without drying it thorough-
ly and brushing off caked dirt. Do not pack stakes or poles inside your tent.
Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. We recommend seam
sealing your tent prior to camping. Seam sealer may be purchased through
your local retailer or at your local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
•
See owners manual for more tips.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous contact with
any flame source.The application of any foreign substance to the tent fabric
may render the flame-resistant properties ineffective.
3
Raise Ends of Tent
–Insert grey shorter shock-corded poles
through pole sleeves at both ends of tent
above windows.
–Insert second pin (located near center of
tent) of pin & ring system into pole end.
–Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pine into the pole end.
–Attach frame clips. (illus.5)
4
Attach Rainfly
–Assemble rainfly pole by interlocking
shock-corded pole.
–Insert rainfly pole into pole sleeves
located at the center edges of the
underside of rainfly. (illus. 7), (illus. 8)
–Drape rainfly over tent, pole side
down. The rainfly pole should
be pointing out over the door
and rear window of tent.
–Insert rainfly pole into grommets
on tent body
–Secure rainfly with attachments
located on underside of rainfly.
– Attach “S” hooks to the loops on
the tent while wrapping stretch cord
around tent pole one time.
–Stake out guylines at the ends
of the rainfly. (illus. 9)
illus. 6 Assembled tent
without rainfly.
illus. 5
Frame clips
illus. 8
Completed tent with rainfly. Note the
guylines on each end, four total.
Grey poles
Grommets for
rainfly poles
End guylines
illus. 9
Stake out the tent with
adjustable guylines.
illus. 7 Insert rainfly
pole through pol
sleeve on underside
of rainfly