Filter
Top Products
3
Raise Center of Tent
– Assemble center shock-corded brace
poles (red sticker, longer poles).
Pole should be initially adjusted to the
inner most hole “A”. (illus. 7)
– Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6, 7)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus 8)
– Repeat for brace poles at front
of screen area.
illus. 5
Shown with both center
brace poles in
position and curved
poles through
center pole
sleeves.
Center brace poles
4
illus. 6 When attaching the
brace poles to the curved
poles make sure that the
brace poles naturally point
straight down.
illus. 9 Tent shown completely set-up. Note the different angles
of the end brace poles.
Raise Ends of Tent
– Assemble end (blue sticker, round ends)
shock-corded brace poles.
– Insert (blue sticker) brace poles into end
roof assemblies. MAKE SURE when
attaching the brace poles to the curved
poles that the bottom of the brace pole
naturally points down and toward the
center of the tent. (illus. 9)
– Brace poles should attach to squeeze
pins at bottom of tent. (illus. 8)
– Adjust poles to accomodate for terrain.
– Drape rainfly over tent, covering the
center and end poles sleeves. Attach
“S” hooks on rainfly into holes in
brace poles. (illus. 9)
Brace pole
Curved
poles in
pole sleeve
Rainfly hooks
to brace poles
PRINTED IN SRI LANKA Rev. 7/04
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
illus. 7
Poles should be initially adjusted to the
inner most hole “A”.
illus. 8
Insert squeeze
pin into pole
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•
Seam sealer has not been provided with your tent. For additional protection
we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous
contact with any flame source.The application of any foreign substance
to the tent fabric may render the flame-resistant properties ineffective.