Filter
Top Products
4
illus. 6 Insert rainfly pole piece into
pockets on underside of rainfly
illus. 8
Hooks attaches to
fabric loop
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN THAILAND
PRINTED IN THAILAND Rev. 10/04
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. For additional protection
we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84. The fabric will burn if left in continuous con-
tact with any flame source. The application of any foreign substance to
the tent fabric may render the flame-resistant properties ineffective.
Underside of rainfly
attaches to tent frame
Attach Tent Rainflys
– Assemble tent rainfly poles by
interlocking shock-corded pole.
– Insert rainfly pole into the pole pocket
located at the center edges of the
underside of rainfly. (illus. 6), (illus. 7)
– Drape rainfly over tent frame, pole side
down. Rainfly pole should be over door
and rear window. NOTE: The toggles on
the rainfly need to run from the front
corners to the top of the tent.
– Connect the four elastic loops with hooks,
(found at the rainfly corners) to the fabric
loops on the bottom row of frame clips.
– Secure rainfly with attachments
located on underside of fly. (illus. 7)
– Repeat for second tent.
Connecting Room
– Layout connecting room and assemble center
ridge and side poles.
– Insert the center ridge pole (gray) through ridge
pole sleeves and insert the pole ends into the
pole pockets. (illus. 9)
– Insert the side poles through the pole sleeves
on connecting room. (illus. 9) Position
connecting room between tents, pole side up.
– Insert one end of side pole onto pin of pin & ring
system on the stability strap. (illus. 3)
– Go to opposite end of pole and gradually apply
pressure to the pole forming an arch until
you are able to insert the pin into the pole.
– Repeat for second pole. (illus. 9), (illus. 10)
– Move tent as needed for better fit with
connecting room. Fully stake down tents.
– Attach connecting room to the tents with
toggles & loops on rainfly and hooking the
stake loop ring at the tent corners. (illus. 10)
– Stake out the tents with (2) side guylines
each and the connecting room with
(4) guylines. (illus. 8)
illus. 7
Both tents fully assembled with rainflys
illus. 9
Connecting room
with center ridge pole
and side poles in position
illus. 10 Both tents and connecting room completed
Guylines
Stability
strap
Toggles & Loops
secure connecting
room to tents
Center ridge
pole sleeves
Pole
pocket
5