Filter
Top Products
4010011274 (ECN20016464-02)
STITCH LINE
6
To Store
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet
clothing inside the tent. It is NOT LEAKAGE through the tent fabric.
It can be minimized by removing wet clothing from your tent and
by providing good ventilation through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping
off tree limbs can cause damage to the tent fabric and its coating
resulting in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying
it thoroughly and brushing off caked dirt. Do not pack stakes or
poles inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER
PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN
PROPERTY DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that
exposure to ultraviolet rays from the sun can seriously damage
material and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A.
1-800-835-3278 • www.coleman.com
MADE IN BANGLADESH
© 2010 The Coleman Company, Inc. All rights reserved.
Coleman
®
, , and are registered trademarks of
The Coleman Company, Inc.
Fig. 9
Fig. 8
Rainfly
Rainfly
Fig. 11
Strap
Pole
Guyline
Fig. 10
“S” Hook
Pole
5
Operate the Tent Lighting
System with Fan
• Align tabs on the Tent Light/Fan with the socket, and gently
rotate clock-wise 1/4 turn to secure into position. (Fig. 12)
• Locate the power cord that was installed into the tent, and
then plug it into the Energy Pack. (Fig. 13)
• Press the left button on the Door Switch for the white light
mode. Push once for “ON” and a second time will turn the
light “OFF”. (Fig. 14)
• Press the right button on the Door Switch for the fan mode.
Press once for “HIGH” fan setting, twice for “LOW” fan
setting, and a third time will turn the fan “OFF”. (Fig. 14)
Note: Additional details can be found in the instruction
sheet included with the tent light/fan system.
Fig. 12
Fig. 13
Fig. 14
Socket
Tab
Tent Light/Fan
Energy
Pack
Right
Button
Left
Button
Door
Switch
Power
Cord
1. Remove tent light/fan and Energy Pack from tent and store them in the carry case.
2. All poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.
3. Make sure tent is clean and dry before placing in carry case.
4. Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.
5. Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.
6. Store in a clean, dry area.