Filter
Top Products
Main Roof Pole, grey
Side Roof Pole, black
Side Roof Pole, black w/Yellow mark
Front & Rear Roof Pole, black w/Green mark
Center Steel Leg Pole w/ red mark
Side Steel Leg Pole
2
2
2
2
4
4
1
2
3
4
5
6
5010000539
5010000539
5010000540
5010000540
N/A
N/A
5010000549
5010000549
5010000548
5010000548
5010000753
5010000761
MODEL 2000008916
Fig. 1
Pole
Sleeve
Fig. 2
Tent Stake
Stake Ring
1
2
3
4
Pole Connector
Top Pole
Leg Pole
Fig. 3
Fig. 4Fig. 5
Pin
Leg
Pole
Fig. 6
Clip
Fig. 7
5
6
STITCH LINE
6
• Insert top poles and leg poles into pole connectors.
(Fig. 3, Fig. 4 and 5)
• Insert the pin into each leg pole. (Fig. 6)
TENT SETUP INSTRUCTIONS
Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of tent
into the wind.
• Enlist the help of at least one other person to assist you when it
is time to assemble the tent.
Pole Descriptions
Description
No.
Qty. Pole
Repair Kit
Pole
Replacement Kit
1
3
4
2
Layout & Positioning
of Tent and Poles
Attach Tent to Leg Poles
Using Clips
Attach Rainfly
Connect Leg Poles
• Attach clips along the edges of tent to leg poles. (Fig. 7)
• Make any adjustments to the tent stakes, if needed.
• Drape rainfly over tent. (Fig. 8 and 9)
• Connect the elastic loops wit
h “S” hooks to the leg
poles. (Fig. 10)
• Secure rainfly with straps located on the underside of
rainfly. (Fig. 11)
• Attach and stake out guylines. (Fig. 9)
HINT: During setup, keep door zipped to keep proper
tension on fabric.
(Continued on other side)
• Layout and position the tent with door facing desired
direction. (Fig. 1)
• Stake down tent corners first through the stake rings. (Fig. 2)
• Keep the floor taut.
• Stake down the remainder of the stake rings.
• Assemble all poles by unfolding and interlocking the shock-
corded pole sections.
• Insert the body poles into the pole sleeves.