Filter
Top Products
Self-rolling Windows
CAUTION: “Springs” may have sharp edges. Handle with care to avoid injury.
Keep out of reach of children.
NOTE: Carefully unroll metal “springs” stored in bag with stakes. The color
marking on each “spring” should match the color of the fabric “flag” sewn to
the window or door sleeve opening. (Fig. 18)
1. Locate sleeve(s) in window panel, open hook &
loop fastener; then insert “spring(s)” with match-
ing color marking. (Fig.18 & 19)
NOTE: When inserting into the sleeve(s), the
color marking on the “spring(s)” should always
face the operator.
2. Close hook & loop fastener to secure.
3. Before unzipping and opening the window,
push in at top to engage “spring(s)” to activate
the self-rolling feature. (Fig. 20)
4. Unzip to allow the window panel to roll down
automatically; zip back to close window panel.
(Fig. 21 & 22)
NOTE: Repeat steps above for inserting the color
matching “spring(s)” into sleeve(s) for the rest of
the windows.
Cooler Access
The smaller zippered opening at the back of
tent is designed for added ventilation and easy
access to your beverage cooler.
1. To use as a vent, unzip flap to expose
screen. (Fig. 23)
2. To use as a cooler access, unzip other flap
to make an avenue to bring beverages into
tent. (Fig. 24)
STITCH LINE
Attaching Room Divider
1. Divider Panel can be installed
through center of the tent by
inserting toggles through the top
and bottom fabric loops as shown.
(Fig. 26 & 27)
Electrical Cord Access
1. Unzip access panel in the lower right
corner of tent and bring in electrical cord.
NOTE: Use only UL approved cords
rated for outdoor usage. (Fig. 25)
4010004524 (20090515)
Fig. 26
Fig. 27
Fig. 24
Fig. 23
Fig. 25
Divider
Panel
To Attach Rainfly
1. Drape Rainfly over tent. Make sure seams on Rainfly are facing down
and centered over curved Ridge Poles at sides of the tent as shown.
(Fig. 17)
NOTE: Large hook and loop fasteners, located at the ends underside
of Rainfly, should be centered over ends of tent.
2. Press hook fastener flaps on underside of Rainfly onto loop pads on
ends of tent to secure. (Fig. 17A)
3. Wrap hook & loop fastener on underside of Rainfly around center Leg
Poles at front and back of tent. (Fig 17B)
4. Insert metal hook on elastic straps on Rainfly into the hole on each
Leg Pole. (Fig. 17 & 17C
)
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that
exposure to ultraviolet rays from the sun can seriously damage material
and/or cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2009 The Coleman Company, Inc.
Coleman
®
, , and are registered trademarks and Rockwall
TM
is a trademark of
The Coleman Company, Inc.
To Store
1. All “springs” must be rolled up and placed in bag with stakes.
2. All poles and stakes must be placed in the storage bag to prevent
damage to the fabric items placed in the carry case.
3. Make sure tent is clean and dry before placing in carry case.
4. Remove rainfly, spread out on floor of tent, then unzip door & vents
before taking tent down for storage.
5. Neatly fold tent to width of pole storage bag, place on tent, roll
tightly, and place in carry case.
6. Store in a clean, dry area.
Door
Window
Panel
Window Panel
Sleeves
Fig. 21
Fig. 20
CAUTION: All “springs” must be removed from sleeves before tearing
down tent to avoid damage to the tent fabric or part. To avoid injury,
carefully roll up “springs”. Keep out of reach of children. Store rolled
“springs in bag with stakes.
Tent Lighting System
Your tent comes pre-wired with the Coleman
®
Tent Lighting
System. See manual that came with the light and carefully read
all instructions before use then save for future reference.
Color
Dot
Fig. 19
Push in at top to
engage “spring(s)”
Fig. 22
Color
“Flag”
Fig. 18
Sleeve
Color “Flag”
Door
Fig. 17
Side of Tent
Front of Tent
Rainfly
17A
17B
17C
5. Stretch guylines until taut, then secure with
stakes. (Fig. 17D)
17D