STITCH LINE
To Set Up Beach Shelter (continued)
To Store
1. All poles and metal stakes must to be placed in the storage
bag to prevent damage to the fabric items placed in the
carry case.
2. Make sure Beach Shade is clean and dry before placing in
carry case.
3. Neatly fold Beach Shade to width of pole storage bag. Place
storage bag on folded Beach Shade, roll tightly, and place in
carry case.
4. Store in a clean, dry area.
To Secure Beach Shade in Sandy Terrain
1. Fill the (6) sand bags with sand or small rocks. (Fig. 14)
2. Insert the toggle of the filled sandbag through the grommet
on the stake loop where the stake would have been. (Fig. 15)
3. Bury the sand bag to secure the Beach Shade.
4. Tie the end of the guy line to the sand bag, extend and bury.
Repeat for second guy line.
12. Extend guy lines out until
taut then secure with stakes.
(Fig. 10 & 11)
Fig. 10
Fig. 11
Fig. 14
11. Attach guy lines to the front of the Beach Shade, above the
large door, by
inserting the guy
line through the
webbing between
the grommet and
the shade material.
(Fig. 9)
NOTE: Use cord located above front door of the Beach Shade
as a dry line.
Rear Vent Flap
The rear flap of the Beach Shade may be raised and lowered to
allow for better ventilation, improve lighting, or privacy.
1. Unzip inside flap to expose mess screen for ventilation.
2. Roll flap up and secure by inserting both dowels through
loops. (Fig. 12)
Fig. 12
Loops &
Dowels
3. Undo outer zipper on rear vent flap and roll up for ventilation
or additional access to Beach Shade.
4. Roll flap up and secure by inserting both dowels through
loops. (Fig. 13)
Fig. 13
Loops &
Dowels
Fig. 9
Fig. 15
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN BANGLADESH • PRINTED IN BANGLADESH
© 2008 The Coleman Company, Inc.
Coleman
®
, , and are registered trademarks of The Coleman Company, Inc.
4010004156 (20081104)
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your shelter. Condensation is caused
by water vapor from your breath, perspiration, or any wet clothing inside
the shelter. It is NOT LEAKAGE through the shelter fabric. It can be
minimized by removing wet clothing from your shelter and by providing
good ventilation through the shelter.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the shelter fabric and its coating
resulting in leaks or loss of flame-resistant properties.
• Never store shelter even for a short period of time, without drying
it thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your shelter. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE SHELTER TO REMOVE STAKES AS THIS COULD RESULT IN
PROPERTY DAMAGE OR PERSONAL INJURY.
• Shelter poles should not be left telescoped together during storage.
• Do not leave your shelter set-up for weeks at a time. Be aware that
exposure to ultraviolet rays from the sun can seriously damage material
and/or cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
Front Door Flap
For additional privacy, the front panel (door) of the Beach Shade
is equipped with a zippered closure.