Filter
Top Products
To Attach Rainfly continued
Fig. 18
STITCH LINE
To Store
1. All poles and stakes must be placed in the storagebag to
prevent damage to the fabric items placed in the carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Remove rainfly, spread out on floor of tent, then unzip
door & vents before taking tent down for storage.
4. Neatly fold tent to width of pole storage bag, place on tent,
roll tightly, and place in carry case.
5. Store in a clean, dry area.
6. Stretch elastic straps and hook clip on
each to the metal loops at the front
and back corners of the tent. (Fig. 10)
7. Extend out vestibule flaps and secure
with metal stakes through the loops in
the web straps. (Fig. 11 & 11A)
8. Stretch guylines until taut, then secure
with stakes. (Fig. 11 & 11B)
11A
Fig. 11
11B
Hinged, Rigid Door
1. Assemble Vertical Door Pole (shorter black
pole with plastic cap tips); then insert
through zippered vertical sleeve on hinged
side of door. (Fig. 12)
2. Insert end of Vertical Door Pole into
bottom hinge plate, apply pressure to form
a slight bow, then insert other tip of pole
into top hinge (Fig. 13). Zip up vertical
pole sleeve.
3. Assemble Door Pole (long, black pole with
plastic cap tips); then insert into zippered
pole sleeve at top of door. (Fig. 13)
4. Insert end of Door Pole into top hinge
plate, apply pressure to form a bow, then
insert other tip of pole into the
bottom hinge. (Fig. 15)
5. Zip up pole sleeve to enclose
Door Pole. (Fig. 16)
Fig. 14
Fig. 16
Fig. 12
Fig. 13
Fig. 15
Electrical Cord Access
1. Unzip access panel in the
lowerleft front corner of tent
and bring in electrical cord.
Use only UL approved cords
that are rated for outdoor
usage. (Fig. 19)
Fig. 19
Cooler Access
The smaller zippered opening at
the back of tent is designed for
added ventilation and easy access
to your beverage cooler.
1. To use as a vent, unzip flap to
expose screen. (Fig. 20)
2. To use as a cooler access,
unzip other flap to make an
avenue to bring beverages
into tent. (Fig. 21)
Fig. 21
Fig. 20
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2008 The Coleman Company, Inc.
Coleman
®
, , and are registered trademarks and Evanston
TM
is a trademark of
The Coleman Company, Inc.
4010003994 (20081009)
Fig. 10
Fig. 17
Door and Window Vents
1. For better ventilation, unzip flap on door, roll down, and
insert toggle into fabric loop to secure. (Fig. 17)
2. To open back and side window vents for more ventilation,
unzip, then roll up and insert toggles through fabric loops.
(Fig. 18)
Pole
Sleeve
Pole Sleeve
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.