Filter
Top Products
A
SSEMBL
Y INSTRUCTIONS
BEFORE A
TTEMPTING TO USE THIS PRODUCT ON THE ICE
practice setting up and taking
down at home in the comfort of a heated area. Repeat several times until comfortable. This will make
your on-ice set-up much easier.
NO
TOOLS
ARE
NEEDED
FOR
ASSEMBL
Y
O
F
YOUR
CLAM 6800.
1.
INITIAL SET
-UP
a. Open the Clam 6800 and lay on a flat level surface.
b. Lift up the two hoop pole sections until the snap button locks into place. Lock the braces.
See Diagram A.
(Both ends.)
c. Unfold the tent and unzip both doors. Pull the tent over the two hoop poles.
d. Above each tent door, on the top of the seam, you will see three velcro strips. Attach the three
velcro strips to the hoop poles.
See Diagram B.
2.
INSE
R
T POLES
a. Insert the four spreader tubes (#7) on each end of the hoop pole.
See Diagram C.
b. Adjust the spreader tubes until the hoop poles are at a 90 degree angle and tent is snug,
then tighten the adjustment knob.
c. Install the two dome poles (#8) in the center of the 6800. Install each dome pole in line wit
h
the velcro on the roof. Attach the velcro to the dome poles.
See Diagram D.
(Note: The dom
e
p
oles ar
e the non
-
ad
j
ustable
p
oles.
)
3.
F
ASTEN THE TENT
a. Fasten the tent to the base by inserting the strap from the tent through the back of the buckle.
See Diagram E.
Pull the strap until the elastic on the buckle starts to stretch. Do not over
stretch the elastic straps.
b. Fold the tab on the buckle over and all the way down to fasten.
See Diagram F
.
(Note: This
onl
y
needs to be done the first time
y
ou set u
p
y
our 6800.
)
4.
INST
A
LL
LICENSE
(Check
with
local
authorities
for the requirements of
your
ar
ea.).
a. Locate the clear sleeve sewn to the outside of the tent. Slide the required documention of
you area into the sleeve for display.
P
a
g
e 6