Citizen JG1 Watch User Manual


  Open as PDF
of 4
 
[Timer time up and auto-chronograph feature]
• At the end of a timing session, an end of session
confirmation beep sounds for 5 seconds, the watch
switches to the chronograph measurement starts.
(Auto-chronograph feature)
✩ Auto-chronograph feature
The auto-chronograph feature can measure up to
24 hours in 1 second start from timer time up.
• Press button
ࠗB
to stop measurement.
• Press button ࠗB
again to repeat the start and stop
cycle.
• Press button
ࠗC
to reset chronograph.
* This auto-chronograph can not use to split
measurement.
[A time up warning beep sounds ON/OFF feature]
Can be switched ON or OFF of a time up warning beep
sounds by pressing button
ࠗB
during pressing button
ࠗA
.
When switch to ON, timer mode mark will flash.
A time up warning beep sounds once at the following
intervals: before the time is up 5, 4, 3, 2, 1 minutes
and every 10 seconds from 50 to 10, 9, 8, ……5, 4, 3,
2, 1.
✩ Fly back feature
The flyback feature is used to restart the timer
anytime after the timer has already been started
Press button
ࠗC
anytime during a timer counting, a
confirmation beep will sound and the timer restart
the moment.
9. All-Reset Operation
After replacing the battery or when the watch’s display
is unusual due to strong shock or intense static
electricity. (No display, alarm continuously sounds
etc.) Perform the all-reset operation as follows:
1) Press buttons
ࠗA
,
ࠗB
,
ࠗC
, and
ࠗM
simultaneously.
2) Release the buttons. All the display segments will
appear.
3) Press any buttons
ࠗA
,
ࠗB
,
ࠗC
, or
ࠗM
. At that time
confirmation will sound. The all-reset operation is
complete. Setting each mode again before using.
10. Precautions
Water resistance
“WATER RESISTANT” may sometimes be
abbreviated as “WATER RESIST”
* Always set the crown in the normal position
 previous