Filter
Top Products
LEDsplash™ 152B User Manual 11 3/9/2010 3:02 PM
4. OPERATING INSTRUCTIONS
Operation
Stand-Alone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1) Set dipswitches position to Sound Active or Auto Mode.
Mode Dipswitches
Sound Active 1~10 = Off, switch set to Music
Auto Mode 1~10 = Off, switch set to Auto
2) The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode, or the unit will auto change in Auto Mode.
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller. In this mode, the first unit
in the daisy chain will automatically command all other units following.
1. Connect all LEDsplash™ 152B units in a daisy chain fashion as described in the section following.
2. Dipswitch settings on slave fixtures are not required and will have no effect.
3. Set all dipswitches on the Master unit to the “Off” position and the unit will run its built in color
change program.
OPTIONS
- Set Music/Auto switch to Music and for sound-activated triggering of the program
- Set Music/Auto switch to Auto then use the rotary dial to adjust speed of the program
- See below under DIP switch Options for additional program settings
Dipswitch Functions
FUNCTIONS
DIP SWITCHES ( ON )
NOTES & DESCRIPTION
Color change program
(Auto/Music)
None
Music/Auto switch
Music: Sound-Activated, sound adjustment knob sets sensitivity
Auto: sound adjustment know sets speed of program
Red LEDs
1
Low Intensity
2
Medium Intensity
3
Full Intensity
Green LEDs
4
Low Intensity
5
Medium Intensity
6
Full Intensity
Blue LEDs
7
Low Intensity
8
Medium Intensity
9
Full Intensity