Filter
Top Products
2 REV 100151-20140919
ENGLISH 100151
ASSEMBLY
This product ships from our factory partially assembled.
Clear away a dry clean space on the floor or a table to
assemble the bike carrier.
Remove all contents from the packing box and locate all
components.
1. Insert the square hitch tube (1) into the receiver tube
of your vehicle. Secure before next step.
2. Insert the support pole (10) into the square hitch
tube (1) making sure to align bolt holes.
3. Secure the support pole (10) to the square hitch tube
(1) using an M12 x 90 bolt (2), two M12 washers (3)
and M12 lock nut (4).
4. Secure the position of the support pole with the
Straight Pin (20) and R-Pin (5).
5. Install the folding stop by placing the M12 x 90 bolt
(2) through the black rubber pipe (9) and securing with
two M12 washers (3) and M12 lock nut (4).
6. Slide the horizontal bar (13) over the support pole
(10) and secure with M8 x 60 bolts (11) and M8 lock
nut (12).
If the bike carrier is not properly installed, possible
property damage and bodily injury may occur. Please
read and fully understand all instructions before starting
assembly. If any questions arise please call our help line
at 1-877-338-0999.
NOTE
10
1
4
3
2
20
5
4
3
2
9
13
10
11
12