Filter
Top Products
Operation Guide 5196/5252/5301
E-54
Specifi cations
Accuracy at normal temperature:
±
15 seconds a month (with no signal calibration)
Timekeeping: Hour, minutes, seconds, day
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Time Calibration Signal Reception: Auto receive up to three times a day
(Remaining auto receives cancelled as soon as one is successful);
Manual receive
Receivable Time Calibration Signals:
Fukushima, Japan (Call Sign: JJY, Frequency: 40.0 kHz); Fukuoka/
Saga, Japan (Call Sign: JJY, Frequency: 60.0 kHz); Shangqiu City,
Henan Province, China (Call Sign: BPC, Frequency: 68.5 kHz)
Other: Power Saving; Auto second hand home position correction
Power Supply: Solar panel and one rechargeable battery
Approximate battery operating time: 5 months (no exposure to light after a full
charge; one signal reception of approximately 4 minutes per day)
E-53
■ Signal reception is being performed successfully, but the time is wrong.
Possible Cause Remedy Page
Your location setting is wrong.
Check your location setting and correct it,
if necessary.
E-32
The watch may have been exposed
to magnetism or strong impact, which
has caused problems with proper
hand alignment.
Adjust the watch’s hand home positions. E-43
E-52
■ The current time setting changes after I set it manually.
You may have the watch confi gured for Auto Receive of the time calibration signal
(page E-28), which will cause the time to be adjusted automatically according to your
currently selected location. If this results in the wrong time setting, check your location
setting and correct it, if necessary (page E-32).
■ Auto Receive is not performed or I cannot perform Manual Receive.
Possible Cause Remedy Page
Your location setting is wrong.
Check your location setting and correct it,
if necessary.
E-32
There is not enough power for signal
reception.
Expose the watch to light to charge it. E-14
E-51
■ The
x
Second Hand indicates N (NO) when I check the result of the latest
receive operation.
Possible Cause Remedy Page
You are wearing or moving the
x
watch, or performing a button
operation during the signal receive
operation.
The watch is in an area with poor x
reception conditions.
Keep the watch in an area where reception
conditions are good while the signal receive
operation is being performed.
E-26
You are in an area where signal
reception is not possible for some
reason.
See “Approximate Reception Ranges”. E-24
The calibration signal is not being
transmitted for some reason.
Check the website of the organization x
that maintains the time calibration signal
in your area for information about its
down times.
Try again later. x
—
E-50
■ The hands and/or day indications are off.
This could indicate that the watch has been exposed to magnetism or strong impact,
which has caused problems with proper hand and day alignment. Adjust the watch’s
hand and day home position alignment (page E-44).
Charging
■ The watch does not resume operation after I expose it to light.
This can happen after the battery charge level drops to Level 4 (page E-16). Continue
exposing the watch to light until the
x
Second Hand starts moving normally (at one-
second intervals).
Time Calibration Signal
The information in this section applies only when CN (HKG, HONG KONG), or
JP (TYO, TOKYO) is selected as the current location.