Filter
Top Products
Operation Guide 4383
4
Timekeeping
• The year can be set in the range of 2000 to 2099.
• The watch’s built-in full automatic calendar makes allowances for different month
lengths and leap years. Once you set the date, there should be no reason to change
it except after you have the watch’s battery replaced or when battery power drops to
Level 3.
• The date will change automatically when the current time reaches midnight. The
date change at the end of the month may take more time than normal.
• The current time for all time zones in the Timekeeping Mode is calculated in
accordance with the Greenwich Mean Time (GMT) differential of each zone, based
on your Home Time Zone time setting.
• GMT differential is calculated by this watch based on Universal Time Coordinated
(UTC*) data.
*UTC is the world-wide scientific standard of timekeeping. It is based upon
carefully maintained atomic (cesium) clocks that keep time accurately to within
microseconds. Leap seconds are added or subtracted as necessary to keep UTC
in sync with the Earth’s rotation. The reference point for UTC is Greenwich,
England.
Power Saving
Power Saving enters a sleep state automatically whenever the watch is left for a
certain period in an area where it is dark. The table below shows how watch functions
are affected by Power Saving.
• There are actually two sleep state levels: “second hand sleep” and “function sleep”.
• Wearing the watch inside the sleeve of clothing can cause it to enter the sleep state.
• The watch will not enter the sleep state between 6:00 AM and 10:59 PM. If the
watch is already in the sleep state when 6:00 AM arrives, however, it will remain in
the sleep state.
To recover from the sleep state
Perform any one of the following operations.
• Move the watch to a well-lit area.
• Press any button.
Operation
Second hand only is stopped, all other functions are
enabled.
• All functions, including analog timekeeping, disabled
• Internal timekeeping maintained
Elapsed Time in Dark
60 to 70 minutes
(second hand sleep)
6 or 7 days
(function sleep)
• This watch can receive signals that differentiate between leap years and non-leap
years.
• Though this watch is designed to receive both time data (hour, minutes, seconds)
and date data (year, month, day), certain signal conditions can limit reception to time
data only.
• If you are in an area where proper time calibration signal reception is impossible, the
watch keeps time within ±20 seconds a month at normal temperature.