Filter
Top Products
Operation Guide 2790
4
Auto light switch precautions
• The auto light switch is automatically turned off
whenever battery power is at Level 3.
• Avoid wearing the watch on the inside of your wrist.
Doing so causes the auto light switch to operate when it
is not needed, which shortens battery operating time. If
you want to wear the watch on the inside of your wrist,
turn off the auto light switch feature.
• Illumination may not turn on if the face of the watch is
more than 15 degrees above or below parallel. Make
sure that the back of your hand is parallel to the ground.
• Illumination turns off in about one second or three
seconds, even if you keep the watch pointed towards
your face.
• Static electricity or magnetic force can interfere with proper operation of the auto
light switch. If illumination does not turn on, try moving the watch back to the starting
position (parallel with the ground) and then tilt it back towards you again. If this does
not work, drop your arm all the way down so it hangs at your side, and then bring it
back up again.
• Under certain conditions, illumination may not turn on until about one second after
you turn the face of the watch towards you. This does not necessarily indicate
malfunction of the auto light switch.
• You may notice a very faint clicking sound coming from the watch when it is shaken
back and forth. This sound is caused by mechanical operation of the auto light
switch, and does not indicate a problem with the watch.
More than 15 degrees
too high