Filter
Top Products
2263-2
ALARM MODE
When the Daily Alarm is turned on, the alarm
sounds for 20 seconds at the preset time each day.
Press any button to stop the alarm after it starts to
sound. When the Hourly Time Signal is turned on,
the watch beeps every hour on the hour.
•
The alarm sounds when the time selected for basic
timekeeping in the Timekeeping Mode (TIME 1 or
TIME 2) matches the alarm time you set.
To set the alarm time
1.Hold down
AA
AA
A while in the Alarm Mode. The hour
digits flash on the display because they are
selected.
At this time the Daily Alarm is turned on
automatically.
2.Press
CC
CC
C to change the selection in the following
sequence.
Hour
Minutes
3.Press
DD
DD
D to increase the selected digits and
BB
BB
B to decrease them. Holding down
either button changes the selection at high speed.
• The format (12-hour and 24-hour) of the alarm time matches the format you
select for normal timekeeping.
• When setting the alarm time using the 12-hour format, take care to set the time
correctly as morning (no indicator) or afternoon (P).
4.After you set the alarm time, press
AA
AA
A to return to the Alarm Mode.
• If you do not operate any button for a few minutes while a selection is flashing,
the flashing stops and the watch goes back to the Alarm Mode automatically.
To switch the daily alarm and hourly time signal on and off
Press
DD
DD
D while in the Alarm Mode to change the status of the daily alarm and
hourly time signal in the following sequence.
To test the alarm
Hold down
DD
DD
D while in the Alarm Mode to sound the alarm.
Hourly Time
Signal Only
Daily Alarm
Only
Both OFFBoth ON
Alarm on indicator
Hourly time signal on indicator
(a) Elapsed time measurement
DD
DD
D
DD
DD
D
DD
DD
D
DD
DD
D
AA
AA
A
Start Stop Re-start Stop Clear
(b) Split time measurement
DD
DD
D
AA
AA
A
AA
AA
A
DD
DD
D
AA
AA
A
Start Split Split release Stop Clear
(c) Split time and 1st-2nd place times
DD
DD
D
AA
AA
A
DD
DD
D
AA
AA
A
AA
AA
A
Start Split Stop Split release Clear
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
First runner
finishes.
Second runner
finishes.
Record time of
first runner.
Record time of
second runner.
STOPWATCH MODE
The Stopwatch Mode lets you measure elapsed
time, split times, and two finishes. The range of
the stopwatch is 59 minutes, 59.99 seconds.
Mode indicator
Current
time
Minutes
Seconds
1/100 seconds
AUTO DISPLAY FUNCTION
The Auto Display function of this watch continually changes the contents of the display.
Note that you cannot use any of the watch’s other functions while the Auto Display
function is operating.
To turn the Auto Display on
Hold down
CC
CC
C for about two or three seconds in any mode until the watch beeps.
To turn the Auto Display off
Hold down
CC
CC
C for about two or three seconds until the watch beeps. At this time the
watch is in the Timekeeping Mode.
Note
The Auto Display function cannot be performed while you are making settings (i.e.
while digits or other setting are flashing on the display).
ADL ADELAIDE +9.5
ANC ANCHORAGE –09
BER BERLIN +01
BKK BANGKOK +07
CAI CAIRO +02
CCS CARACAS –04
CHI CHICAGO –06
DAC DHAKA +06
DEL DELHI +5.5
DEN DENVER –07
DXB DUBAI +04
GUM GUAM +10
HKG HONG KONG +08
HNL HONOLULU –10
IST ISTANBUL +02
JED JEDDAH +03
JRS JERUSALEM +02
KBL KABUL +4.5
KHI KARACHI +05
LAX LOS ANGELES –08
LON LONDON +00
MEX MEXICO CITY –06
MIA MIAMI –05
MIL MILAN +01
MLE MALE +05
NOU NOUMEA +11
NYC NEW YORK –05
PAR PARIS +01
PPG PAGO PAGO –11
RGN YANGON +6.5
RIO
RIO DE JANEIRO
–03
ROM ROME +01
SEL SEOUL +09
SFO
SAN FRANCISCO
–08
SIN SINGAPORE +08
SYD SYDNEY +10
THR TEHRAN +3.5
TYO TOKYO +09
WLG WELLINGTON +12
YVR VANCOUVER –08
CITY CODE TABLE
City Code City GMT differential
*
Based on data as of December 1997
.
Mode
indicator
Minutes
Hourly time
signal on
indicator
Alarm on
indicator
PM
indicator
Hour
Current time