Filter
Top Products
2235-3
• Hourly Time Signal indicator 1 is displayed in all modes
when the Hourly Time Signal is turned on.
• Hourly Time Signal indicator 2 is displayed in the Alarm
Mode only. It shows on when the Hourly Time Signal is
on, and OF when the Hourly Time Signal is off.
To test the alarm
In the Alarm Mode, display the alarm you want to sound,
and then press E to play its melody or beep. You can
also press E to play an alarm’s melody while setting the
alarm time.
• To stop a playing melody or beep, press any button.
About the harmony
Paired G-Shock and Baby-G models play the melodies in
harmony.
STOPWATCH MODE
The stopwatch Mode lets you measure elapsed time, split
times, and two finishes. The range of the stopwatch is 23
hours, 59 minutes, 59.99 seconds. You can use the EL
backlight by pressing E at any time while the stopwatch
is operating.
Hourly Time Signal
indicator 1
Hourly Time Signal
indicator 2
Mode indicator
Hours
Minutes
Seconds
1/100 second
Current tim
e
Elapsed time measurement
Start
Stop Re-start Stop Clear
Start
Split Split release Stop Clear
Start
Split Stop Split release Clear
Split time measurement
Split time and 1st-2nd place times
First runner
finishes.
Second runner
finishes.
Record time of
first runner.
Record time of
second runner.
MEMO MODE
The Memo Mode lets you store up to five memos, each
with an eight-character title and 16 characters of data.
Recalling a Memo
In the Memo Mode, press D to scroll through the Memo
titles. When you find the title you want, press B, and the
screen alternates between the title and data.
• The display can show only five characters at a time.
Longer text scrolls continuously from right to left. The
symbol “
” indicates that the character or digit to the
left is the last, and the character or digit to the right is
the first.
• A series of hyphens “ – – – – – ” is displayed for a memo
that does not contain any data.
Mode indicator
Memo number
Title
To input a memo
1.In the Memo Mode, press D to display the memo number you want to set.
2.Hold down A until the first (leftmost) character of the memo title starts to flash on
the display. This indicates the input screen.
3.Press C to move the flashing in the sequence shown below. Press E to move
the flashing in the opposite direction.
Press . Press .
Title Character 8
Data Character 1
Title Character 1
Data Character 16
4.Use D or B to scroll through characters at the current location of the flashing.
Holding down either button scrolls at high speed.
Press . Press .
Space A to Z
Punctuation
Japanese
characters
Hyphen SymbolsNumbers
∗
See the “CHARACTER LIST” for details.
• Pressing D and B at the same time while inputting memo title or data clears all
title and data. At this time the message “CLEAR” appears on the display.
5.After you input the data you want, press A to exit the input screen.
CHARACTER LIST
MELODY LIST
January 1 ?????
December 25 ?????
Other days I don’t want to miss a thing