Filter
Top Products
1993/2075-1
Module No. 1993/2075
ABOUT THIS MANUAL
A
C
B
M
L
P
(LIGHT)
(MODE)
A
C
B
M
L
P
(LIGHT)
(MODE)
[Module 1993]
[Module 2075]
GENERAL GUIDE
A
C
B
M
L
P
Telememo Mode
▲
▲
▲
▲
Identification (ID) Mode
Vital Statistics Mode
▲
▲
Timekeeping Mode
Alarm Mode
Stopwatch Mode
• The operational procedures for Module 1993 and 2075 are identical. All of the illustrations
in this manual show Module 1993.
• Button operations are indicated using the letters shown in the illustration.
• Press M to change from mode to mode. Each mode is explained in detail on the
following pages.
• In any mode, press L to illuminate the display.
TIMEKEEPING MODE
In addition to normal timekeeping, the Timekeeping Mode
is also used to set the current time and date, and to turn the
EL alarm on and off.
• In the Timekeeping Mode, graphic area indicates counting
of seconds.
To set the time and date
1. Press A while in the Timekeeping Mode. The seconds
digits flash on the display because they are
selected
.
2.Press M to change the selection in the following
sequence.
Seconds
Hour
Minutes
12/24-hour
format
Year
MonthDay
3. While the seconds digits are selected (flashing), press B to reset the seconds to 00.
If you press B while the seconds count is in the range of 30 to 59, the seconds are
reset to
00 and 1 is added to the minutes. If the seconds count is in the range of 00
to 29, the minutes count is unchanged.
4. While any other digits (besides seconds) are selected (flashing), press B to increase
the number. While the 12/24-hour setting is selected, press B to switch between the
two formats.
• Holding down B changes the current selection at high speed.
• When the 12-hour format is selected, the
12H indicator appears on the display. With
the 12-hour format, the P (PM) indicator appears on the display to indicate “p.m.”
times. There is no indicator for “a.m.” times.
• Selecting the 24-hour format causes the
24H and the 24 indicators to appear on the
display.
5. After you set the time and date, press A to return to the Timekeeping Mode.
• The day of the week is automatically set in accordance with the date.
• The date can be set within the range of January 1, 1995 to December 31, 2039.
• If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Timekeeping Mode automatically.
A
C
B
M
L
P
Month – Day
Year
Minutes
Seconds
PM indicator
Hour
Day
of week
Graphic area
To turn the EL alarm on and off
In the Timekeeping Mode, hold down B for one or two
seconds to toggle the EL alarm on (
displayed) and off
(
not displayed).
• The EL alarm on indicator remains on the display in all
modes until you switch the EL alarm off.
• The above operation controls operation of the EL alarm
only. It does not affect operation of audible tones and
signals.
• When an alarm is reached while the EL alarm is turned
on, the flashing of the backlight and the timing of the alarm
tones may not be exactly matched. This is normal and
does not indicate malfunction.
BACKLIGHT
The backlight uses an EL (electro-luminescent) panel that causes the entire display to
glow for easy reading in the dark. An EL alarm feature can be turned on so the backlight
flashes whenever an alarm or hourly time signal sounds.
• Pressing L in any mode illuminates the display for about three seconds, regardless
of the EL alarm on/off setting.
• The backlight of this watch employs an electro-luminescent (EL) light, which loses its
illuminating power after very long term use.
• The backlight remains lit for about three seconds from the point you press L, even if
it already lit when you press L. If you keep L depressed for one or two minutes, the
backlight will automatically turn off.
• The illumination provided by the backlight may be hard to see when viewed under
direct sunlight.
• The backlight automatically stops illuminating whenever an alarm sounds.
• The watch will emit an audible sound whenever the display is illuminated. It does not
indicate malfunction of the watch.
A
C
B
M
L
P
EL alarm on indicator
TELEMEMO MODE
The Telememo Mode lets you store up to 20* pairs of name
and telephone number data. Stored data is sorted
automatically into alphabetic sequence based on the
characters of the name.
* The Telememo Mode shares memory with the Identification
(ID) Mode. This means that the maximum number of
Telememo Mode entries you can store is reduced by one
each time you store Identification Mode.
To check remaining memory
In the Telememo Mode, hold down B and C to display
how much memory remains for input of data. The value that
appears shows how many more data items (Telememo Mode
and ID Mode) you can input.
• This watch has three built-in ID Mode titles, which are programmed in memory when
you first purchase the watch and which are automatically set whenever the watch’s
battery is replaced. Because of this, the remaining memory display shows a value of
17 (20 – 3) whenever it is performed immediately after you purchase the watch or
have the battery changed.
To input new Telememo data
1. In the Telememo Mode, press B or C until the new
data screen appears.
• If there is no Telememo data stored in memory yet, the
new data screen appears as soon as you enter the
Telememo Mode.
• If the message
FULL appears in the text area, it means
that memory is full. To store more data, you will first have
to delete some of the data stored in memory.
2. Press A and a cursor appears in the text area.
3. Input a name in the text area and a telephone number in
the number area.
• You can input up to eight characters in the text area, and
12 digits in the number area.
A
C
B
M
L
Number area
A
C
B
M
L
Cursor
Text area
Text area
Mode indicator
Number area
[New Data Screen]
Use B and C to input characters, and M to move the cursor around the display.
For details, see “How to input characters”.
• Make sure that you distinguish between the letter
O and the number 0 (zero). Inputting
a zero for the letter
O will affect automatic sorting.
4. After inputting your data, press A to store it and return to the Telememo Mode.
• The text area can show only five characters at a time, so longer messages scroll
continuously right to left.