Filter
Top Products
1675-1
C
D
BA
P
Module No. 1675
A
A
°
C
m
RECALL
AUTO
ALTI
AUTO
P
°
C
m
ALTI
AUTO
2 seconds later
• Press C to change from mode to mode.
• Hold down C for one or two seconds in any mode to switch back to the
Timekeeping Mode.
Timekeeping Mode
Stopwatch Mode
▼
Recall Mode
Alarm Mode
▼
▲
▲
( Timekeeping Display)
Press D.
Altimeter Mode
GENERAL GUIDE
▼
C
D
BA
P
P
°
C
hPamb
Sensor
( Pressure/Temperature
Display )
P
AUTO
P
AUTO
AUTO
BACKLIGHT
This watch features an electroluminescent (EL) backlight that helps you
easily read the face, even in total darkness. Its Auto Backlight function
automatically lights the watch face whenever you turn your wrist towards your
face.
Note
• The backlight of the watch employs an electroluminescent (EL) light, which
loses illuminating power after very long use.
• Frequent use of the backlight shortens the battery life.
• The illumination provided by the backlight may be hard to see when viewed
under direct sunlight.
• The watch will emit an audible sound whenever the display is illuminated.
This is caused by a transistor that vibrates when the EL panel lights up. It
does not indicate malfunction of the watch.
• The backlight automatically turns off whenever an alarm sounds or when
you press the C or D button.
To manually turn on the backlight
In the Timekeeping Mode or the Altimeter
Mode, press B to illuminate the display for
about two seconds.
• The backlight remains lit for about two
seconds from the point you press B, even
if it is already lit when you press B. If you
keep B depressed for one or two minutes,
the backlight will automatically turn off.
To switch the auto backlight function on and off
In the Timekeeping Mode, hold down D for one or two seconds to turn the
auto backlight function on and off.
• The auto backlight indicator is shown on the display in all modes while the
auto backlight function is on.
• In order to protect against running down the battery, the auto backlight
function is automatically turned off approximately two or three hours after
you turn it on. Repeat the above procedure to turn the auto backlight
function back on if you want.
• Pressing B in the Timekeeping Mode or Altimeter Mode illuminates the
display for about two seconds, regardless of the auto backlight function on/
off setting.
About the Auto Backlight function
While the Auto Backlight function is turned on, the backlight automatically
lights for about two seconds in any mode whenever you position your wrist as
described below.
Auto backlight
indicator
OFFON
Important!
Avoid wearing the watch on the inside of your wrist. Doing so causes the Auto
Backlight to operate when it is not needed, which shortens battery life.
Moving the watch to a position that is parallel to the ground and then tilting
it towards you more than 40 degrees causes the backlight to illuminate.
• The backlight may not illuminate if the face of the watch is more than 15
degrees off parallel as shown below. Make sure that the back of your hand
is parallel to the ground.
• Static electricity or magnetic force can interfere with proper operation of the
auto backlight function. If the auto backlight does not illuminate, try moving
the watch back to the starting position (parallel with the ground) and then tilt
it back toward you again. If this does not work, drop your arm all the way
down so it hangs at your side, and then bring it back up again.
• Under certain conditions the backlight may not light until about one second
or less after turn the face of the watch towards you. This does not necessarily
indicate malfunction of the backlight.
Warning!
• Never try to read your watch when mountain climbing or hiking in
areas that are dark or in areas with poor footing. Doing so is dangerous
and can result in serious personal injury.
• Never try to read your watch when running where there is the danger
of accidents, especially in locations where there might be vehicular or
pedestrian traffic. Doing so is dangerous and can result in serious
personal injury.
• Never try to read your watch when riding on a bicycle or when
operating a motorcycle or any other motor vehicle. Doing so is
dangerous and can result in a traffic accident and serious personal
injury.
• When you are wearing the watch, make sure that its auto backlight
function is turned off before riding on a bicycle or operating a
motorcycle or any other motor vehicle. Sudden and unintended
operation of the auto backlight can create a distraction, which can
result in a traffic accident and serious personal injury.
Parallel to ground
Parallel to
ground
More
than
40°
More than 15
degrees too high
More than 15
degrees too low