Filter
Top Products
4
Side Rail Mounting
Side/Rail mounts can be mounted to a
welded T-section. It can also be used at the two
rail section butt joint. In both installations it is
recommended to use a non-slip material, such
as rubber or a thin wood sheet, between metal
surfaces.
You can also use these for mounting to a very
narrow side gunwale. There is a plate provided
for back-up with bolts and washers. If the
gunwale compartment is foamed in, then
wellnuts should be used. It is also recommended
to install two additional flat head screws through
the top plate for stabilization (you will need to
drill and countersink).
NOTE: In no case should this mount be used
on fiberglass ¼" thick or less unless it is
foamed in.
Pedestal Mounting
Pedestals are used wherever additional height is
needed for ease of operation or to clear
obstructions, such as handrails.
Caution: When using a pedestal mount
or side/rail mount, do not extend the
telescopic boom on your Mag 10 HS \
Mag 10 TS. The increased leverage
will cause excessive strain and
possible failure of the mount.
Side/Rail on T-Section
Side/Rail on Gunwale
Pedestal for Additional Height
MOUNTING & SETUP