Filter
Top Products
4
Side Rail Mounting
Side/Rail mounts can be mounted to a welded
T-section. It can also be used at the two rail
section butt joint. In both installations it is
recommended to use a non-slip material, such as
rubber or a thin wood sheet, between metal
surfaces.
You can also use these for mounting to a very
narrow side gunwale. There is a plate provided for
back-up with bolts and washers. If the gunwale
compartment is foamed in, then wellnuts should
be used. It is also recommended to install two
additional flat head screws through the top plate
for stabilization (you will need to drill and
countersink).
Side/Rail on T-Section
Side/Rail on Gunwale
MOUNTING & SETUP
NOTE: In no case should this mount be used
on fiberglass ¼" thick or less unless it is
foamed in.
Pedestal Mounting
Pedestals are used wherever additional height is
needed for ease of operation or to clear
obstructions, such as handrails.
Caution: When using a pedestal mount or
side/rail mount, do not extend the telescopic
boom on your Easi-Troll HS \ Lake-Troll. The
increased leverage will cause excessive
strain and possible failure of the mount.
Pedestal for Additional Height