Filter
Top Products
5
Pedestal Mount \ Accessory Compatibility
Replacement Parts
Mounts
Pedestal
○○●
6" Swivel Mount
●○○
●
- Compatible
○
- Not Compatible
4" Swivel Mount
Track Mount Gimbal Track Mount Pedestal Track Mount
●○○
4" Fixed Mount
6" Fixed Mount
Rail Mount Clamp Mount Deck Mount
●○○○○●
○○●
●○○○○●
Part Part Number Description USED ON
3393413 THUMB SCREW 1904030, 1904031, 1904032, 1904033
Troubleshooting - Swivel Pedestal
Problem: Pedestal will not rotate when the lock pin is disengaged.
Make sure the downrigger line is all the way up. Any load on the downrigger or pedestal may prevent the pin from
disengaging. Spray a lubricant into the slot which the lock pin slides. Make sure lock pin moves freely up / down.
Problem: Pedestal rotates while in locked position under normal use.
The break away bolts are not tight enough. Re-torque bolts to 25 ft-lb.
NOTE: Bolts may have to be tightened higher than 25 ft. lbs under some conditions. Do not exceed 35 ft-lb as this may
damage the top plate.
Problem: Pedestal did not breakaway while locked when the boom struck an object.
The break away bolts are over-tightened. Loosen bolts and re-torque to 25 ft. lbs.
Mounting Your Downrigger to the Pedestal Mount
The Cannon Pedestal Mount provides 1/4”-20 tapped mounting holes for attaching most downrigger
mounting bases. To attach a mounting base you will need four 1/4”-20 screws
(not included). To determine the
length of screws needed, measure the thickness of the downrigger mounting base and add 1/2”. See below for
screw lengths for the Cannon Downrigger mounting bases.
Magnum / Digi-Troll Tall Mounting Base — 2” Long Truss Head screw
Uni-Troll Low-profile Mounting Base — 1” Long Truss Head screw
Easi-Troll / Lake-Troll Tab-Lock Base — 3/4” Long Truss Head screw