Filter
Top Products
WARRAN T Y / R EP AIR
One-Year LIMITED WARRANTY
Your Bushnell
®
Laser Rangefinder is warranted to be free of defects in
materials and workmanship for one year after the date of purchase. In the
event of a defect under this warranty, we will, at our option, repair or replace
the product, provided that you return the product postage prepaid. This
warranty does not cover damages caused by misuse or improper handling,
installation or maintenance of the product.
Any return made under this warranty
must be accompanied by the items listed below:
1) A check in the amount of $15.00 to cover the cost of handling
2) Name and address for product return
3) An explanation of the defect
4) Product should be well packed in a sturdy outside shipping
carton to prevent damage in transit and return postage prepaid
to the address listed below:
IN U.S.A. Send To:
Bushnell Performance Optics
8500 Marshall Drive
Lenexa, Kansas 66214
For products purchased outside the United States and Canada please contact
your local dealer for applicable warranty information. This warranty gives you
specific legal rights. You may have other rights which vary from country
to country.
©2001 Bushnell Performance Optics
IN CANADA Send To:
Bushnell Performance Optics
25A East Pearce Street, Unit 1
Richmond Hill, Ontario L4B 2M9
TROUBLE SHOOTING TABLE
Unit does not turn on - LCD does not illuminate:
• Depress power button.
• Check and if necessary, replace battery.
Unit powers down (display goes blank when attempting to power the laser):
• The batteries are either weak or low quality. Replace the batteries with good quality alkaline batteries.
There is no reset button to clear last range reading before ranging another target:
• The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using the
LCD’s reticle, depress the power button and hold until new range reading is displayed.
Target range cannot be obtained:
• Make sure LCD is illuminated.
• Make sure that the power button is being depressed (as opposed to mode button).
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that emit
and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
• Make sure that the targeting mode selected is the appropriate mode for that specific situation / environment. Each
targeting mode (SCAN, REFL, RA I N and >150) has a different minimum distance and sensitivity to a specific target’s
r e f l ec t i v i ty levels.
For further assistance, please contact a customer service representative at 800-423-3537.
2