Filter
Top Products
54
GETTING STARTED
Installing Batteries
This device operates on two AA batteries. To install,
unscrew the battery compartment cover located on the
bottom of the unit. Insert the batteries into the battery
compartment so that the (+) and negative (-) terminals of
the batteries match the markings inside the compartment.
Replace the battery cover carefully – do not over tighten.
Use and Testing
This device operates on two AA batteries. Make sure they
have been installed according to the instructions above.
If you wish to test your night vision device in a lighted area,
be sure the objective lens cap is covering the objective lens
(1) prior to pressing the “ON” button (2). The objective lens
cap has a pinhole opening to admit a small amount of light
for testing purposes.
If testing or using the device in the dark, remove the
objective lens cap and activate the device by pushing the
“ON” button (2).
Set the preliminary focus adjustment by placing the adjusting
mark (located on top of the objective focusing ring) opposite
the letter “N” in the word “Normal”(7).
If the subject is to be viewed in a completely dark area
where no ambient light source (such as moonlight) is
available, activate the Infrared Illuminator by pressing the
Infrared Illuminator button (3) located next to the “ON”
button.
Your Night Vision device offers the worlds’ only Built-In Dual Beam Infrared Illuminator for short and long distance viewing! This
allows you to choose how you wish to disperse the infrared light. Using low beam simply spreads the infrared beam of light
out in all directions. If you desire to send a pinpoint of infrared light to an object far away, use the high beam infrared light.
Switch between High and Low by pressing the button (4) located above the eyepiece.
Direct the device at an object at a distance approximately 100 yards and rotate the eyepiece (5) to give the best quality image.
After the adjusting, do not rotate the eyepiece any longer irrespective of the distance and other conditions. Direct the device
at the subject to be viewed and adjust the final focus by rotating the objective lens focusing ring until the image quality is
optimal.