Filter
Top Products
65
Your Night Vision device offers the worlds’ only Built-In Dual Beam Infrared Illuminator for short and long distance viewing! This
allows you to choose how you wish to disperse the infrared light. Using low beam simply spreads the infrared beam of light
out in all directions. If you desire to send a pinpoint of infrared light to an object far away, use the high beam infrared light.
Switch between High and Low by pressing the button (4) located above the eyepiece.
Direct the device at an object at a distance approximately 100 yards and rotate the eyepiece (5) to give the best quality image.
After the adjusting, do not rotate the eyepiece any longer irrespective of the distance and other conditions. Direct the
device at the subject to be viewed and adjust the final focus by rotating the objective lens focusing ring until the image
quality is optimal.
GETTING STARTED
Installing Batteries
This device operates on two AA batteries. To install, unscrew the
battery compartment cover located on the bottom of the unit.
Insert the batteries into the battery compartment so that the (+)
and negative (-) terminals of the batteries match the markings
inside the compartment. Replace the battery cover carefully – do
not over tighten.
Use and T
esting
This device operates on two AA batteries. Make sure they have
been installed according to the instructions above.
If you wish to test your night vision device in a lighted area, be sure
the objective lens cap is covering the objective lens (1) prior to
pressing the “ON” button (2). The objective lens cap has a pinhole
opening to admit a small amount of light for testing purposes.
If testing or using the device in the dark, remove the objective lens
cap and activate the device by pushing the “ON” button (2).
Set the preliminary focus adjustment by placing the adjusting mark
(located on top of the objective focusing ring) opposite the letter
“N” in the word “Normal”(7).
If the subject is to be viewed in a completely dark area where no
ambient light source (such as moonlight) is available, activate the
Infrared Illuminator by pressing the Infrared Illuminator button (3)
located next to the “ON” button.
Model: 26-0200