Filter
Top Products
angle (where the target surface is perpendicular to the flight path of the emitted energy pulses) provides good
range while a steep angle on the other hand, provides limited ranging. In addition, lighting conditions (e.g. the
amount of sunlight) will affect the ranging capabilities of the unit. The less light (e.g. overcast skies) the farther
the unit’s maximum range will be. Conversely, very sunny days will decrease the unit’s maximum range.
GETTING STARTED
INSERTING THE BATTERY
Remove the battery cap by lifting the battery door tab and then rotating counter clockwise. Insert a CR-2
3-volt lithium battery into the compartment positive end first, then replace the battery cap.
NOTE: It is recommended that the battery be replaced at least once every 12 months.
OPERATIONAL SUMMARY
While looking through the 4x eyepiece, depress the power button once to activate the in-view Liquid Crystal
Display (LCD). Place the aiming circle (located in the center of the field of view) upon a target at least 5
yards away, depress and hold the power button down until the range reading is displayed near the bottom of
the in-view display. Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once
a range has been acquired, you can release the power button. The crosshairs surrounding the aiming circle
will disappear once the power button has been released (i.e. the laser is no longer being transmitted). Note:
Once activated, the LCD will remain active and display the last distance measurement for 30 seconds. You
can depress the power button again at any time to distance to a new target. As with any laser device, it is not
recommended to directly view the emissions for long periods of time with magnified lenses. The maximum
time the laser is transmitted (fired) is 10 seconds. To re-fire, press the button down again.
3