Burley Flatbed Bicycle Accessories User Manual


  Open as PDF
of 2
 
Solid Axle Adapter Installation
Remove non-drive (left) side axle nut and retain. If your hub uses non-turn
washers, these should remain on the axle. Check exposed axle length by
placing Adapter against the dropout (or non-turn washer, if present). If the
axle extends beyond the last band, add one or two of the provided washers
until the axle does not extend beyond the last band.
Axle too long:
add washer
Thread on
the
Adapter
and tighten
to 30 N·m
(22 ft·lb)
using a
6mm hex
key. Do not
over tighten,
as this can
damage the Adapter. Install Burley standard hitch onto the Adapter and
secure using the axle nut removed earlier. Tighten to 20 N·m (15 ft·lb).
Refer to your Burley trailer manual for information on using your Burley hitch.
Eugene, OR USA
PH 541.687.1644 800.423.8445 FAX 541.687.0436
burley@burley.com : burley.com
Hitch Alt Adapter Manual: RTFM: Rev 07.2011
 previous