Filter
Top Products
9
Replacement Parts
Check unit periodically and discontinue use if parts or accessories are found to be damaged or defective. To
replace worn or defective parts, contact Customer Service toll-free at (800) 54-HOW-TO.
12 Volt DC Adapter Plug Fuse Replacement
The fuse in the DC plug protects the charging circuit of the 12 Volt DC Adapter. If AC powering/ recharging works, but DC
powering/recharging does not, then the fuse may be opened (blown).
To replace the fuse:
1. Unscrew the gold end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate replacement fuse with same type and rating.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 Volt DC Adapter.
Bulb Replacement
1. Unscrew the top of the Lantern (refer to Figure 1 below).
2. Remove the bulb assembly (refer to Figure 2 below).
3. Locate the metal spring in the top of the lamp (refer to Figure 3 below).
4. Grasp the metal spring and the lamp base to remove the bulb (refer to Figure 4 below).
5. Replace the bulb with a new 9 watt CFL bulb and re-assemble.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: NEVER grasp the glass bulb directly. It
can shatter.
DO NOT TWIST to remove the bulb; it pulls straight out of the socket.
Battery Replacement/Disposal
Battery Replacement
When it will no longer holds a charge, the
Rechargeable Battery Pack
can be replaced with a new
VEC1198BAT Battery
Pack.
Contact Customer Service toll-free, at (800) 54-HOW-TO to order this part.
The
Internal Backup Power System Battery
should last the life of the unit. In the event it needs replacing, it is recommended
that the unit be returned to manufacturer. Contact Vector Customer Service toll-free, at (800) 54-HOW-TO.
Battery Disposal
This unit contains a sealed lead acid battery and Ni-MH battery and should be disposed of properly. For
more information on recycling batteries, call toll free (800) 822-8837.
WARNING: Do not dispose of the battery in fire, as this may result in an explosion. Before
disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire). Do not expose battery to fire or intense heat, as it may explode.
Accessories
Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you
need assistance regarding accessories, please call: 1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
FIGURE 1
FIGURE 2 FIGURE 3 FIGURE 4
PS50LRB_Manual_120106 12/1/06 11:25 AM Page 9